Відео

Garcia Kimberly Smith Jessica Wilson Betty

I installed 2 different radios and never got the sound I wanted. Only installed for 30 minutes and put back in box. I’m about to sell to a friend just to get it out my garage.

Thomas Jeffrey Martin Christopher Brown William

The check engine light was still on, bro.... that didn't even work for you.

White Jennifer Smith Jason Miller Cynthia

Gonzalez Barbara Allen Daniel Harris James

Hernandez Thomas Perez Richard Hernandez Sandra

Perez Donna Rodriguez Christopher Allen Jennifer

Taylor Thomas Thompson Donna Brown Daniel

Miller Carol Lewis Laura Johnson Michael

Jones Michelle Lee John Jackson Frank

Autel is from Temu as well priced at $343 so far

If your Hummer has the bose system which I'm assuming it does can't blame the radio for the 1% volume being to loud....it's going through the factory amp before the speakers

Can you send one to me

Hope you changed the oil after that first run.

Hi Hayden, Like your video. We sent MG on Ins.

Why are you starting with the slider on turtle mode..? The manual says a notch above full speed. Its no wonder you had to crank it 4 times

Lots of smoke😯😯😯

Cool video greatly appreciated the different vehicles and tests.

I got that timu scanning tool and it's not picking up two issues that I have come up on my dash. I would say it is a bit of a hit and miss with that one. You may get lucky and it will work for you, it's not working on my car though.

What if it rains?

When you have money and no common sense

These are some of the best mowers out there and they prove it over and over 😊

Thank you Dr. in NJ :)

It says no codes stored in the module does it mean it’s working or my car is fine

Thank you for your video I just actually got the exact same one? Haven't used it as yet. Thanks again.

I have a E46 320d. The OBD “Carly” shows me 7 codes, and 4 of them are important ones like airbag…But this piece of shit only shows me 2 and there are not even important(just shows a/c blower). Imagine going to buy a car and look after fault codes with Temu’s obd… I would buy a car with 0 faulty codes but in reality it has hard ones. Wasted money

😀Thanks

Depends on what the device is programmed to, all you need is a better program in the cheaper device

Does it still work. Did it turn to the white screen everyone is talking about

How do you change a t7rn signal light with brush guard on

never understand why people full throttle then pull pto in ? its like if you had a manual car full throttle 1st gear then droping your foot off the clutch !!

Yes that seat drove me crazy also put a cable from truck back gate works well.

You can't play with your radio while you are backing up?😮

For the avg driver the $20 reader is a thing of convenience. Once most people get the code they get someone else to repair it, if that’s you? Why even spend the $20? All the parts stores will read it for free. If you are a DIY you would still benefit from free reads by the parts places, unless you are constantly working on your car or friends cars, then a good scanner can save you valuable time in diagnosing and making repairs. If you are a professional, you already have a collection of scanners as some do better with certain makes. I keep a couple of OBII Handheld scanners. I’ve bought them at TEMU for less than $15 same scanners on Amazon for $50. I keep one in each vehicle, but there is no replacement for the scanners if you consistently work on cars. It would be like comparing an adjustable wrench to a master tool set. Bottom line it comes down to what you are gonna use it for. FYI a lot of people are under the impression that if you erase the codes the problem is fixed. The computers all talk to each other, when something gets out of tolerance it triggers a code, the check engine light comes on to alert you that there is a problem and it needs repair. Driving it after erasing the codes is only damaging your engine, transmission and or computers. People will spend thousands for a car, but skip or extend oil changes. Oil is the life of your car. You want your car to last? Run good oil and change it every 3,000 miles. Even synthetic! They say you can go 5,000, 10,000 and more, but you are making a huge investment in a car, don’t be cheap, change the oil and run good gasoline. Don’t be cheap, the repairs won’t be I promise…

Just use Bluetooth

I got mine in today Walmart for $44

U just reset the oil light. Lol

No apple play is no big deal-apple is for Disney type people trying to buy their status. Android is for Lego type people

The humming is a ground issue the stereo resetting is also a ground issue check your wiring and everything the volume won't go up when on reverse with the camera you can remove that feature by bypassing the park wire by self grounding it

The $580 difference is the Bi-directional control. Apples to oranges buddy. The $20 reader is just a reader, the Autel is a diagnostic tool. The $20 reader is what I would give to one of my customers if there was an intermittent issue, they can scan and record the code for me. I would throw that one in my wife or kids car. My Autel used to travel everywhere I went, now I use an Otofix D1. Much cheaper to own with most of the same control.

Good advise! Thx!

Hi came across this video I have a pioneer radio myself if you go in to the setting then speakers scroll down to speaker settings you can set each speaker to adjust the main volume evan the subwoofer good luck

It got android mirror link

So wich one its better??

U reviewing the wrong radio they have Apple play on it now

But you can also buy a sub 200 xtool scanner which also has bidirectional function… I have xtool and autel and both have bidirectional functions and read bcm pretty well

I was driving on freeway and all sudden my abs, Trak control light, the check engine code flashing. now power like I was towing 20 vehicles and hard shifting. Any ideas why this happens 2013 chevy avalancche 5.3. From what I read online this is issues with these trucks. any ideas why this happens .

Mine i replaced pedal throttle body injection system purge system o2s and kept getting a pedal code i cleaned grounds buy drivers door and for body to engine and still did it put fuel pump i threw everything at it and the issue was so stupid simple and over looked i hope that this helps the battery had a dead cell and the ecm pcm bcm one of them detected that but gave a pedal code why no clue replaced battery runs like normal what a journey

That thing is super low end. If you need something, it works but i wouldnt get it for my car