Відео

💀

I bet two billion percent that not only is it not as good as a gas burner and it actually uses a lot of energy

@@BeoooPhát But one electrolysis unit produces a lot of oxygen and 60 liters of hydrogen from 30 liters of water! For now, the gas burner is capable of heating 30 liters of water using 0.2 liters! There is no need to put up a bunch of buildings and pipes yet!

@North_country. i will try

@North_country. a heat exchanger will use 400 liters of distilled water per second and each electrolysis will supply hydrogen to at least 5 gas burners and each gas burner will produce 30 liters of hot distilled water so 12 gas burners will be needed

It depends, are you using foced labor?

Yeah

you need to connect and disconnect the data cables from each turbine to the next if thats what your asking

Yes after sync 1 turbine removed connection

If there are a lot of models on the server, then with large volumes of fluid, it just disappears somewhere in the pipes

If you click the base of a pole then click the thing which u wana power it joins all 4 lines in one click

Is the turbine not spinning on principle or not generating electricity?

it’s i don’t even know it’s not spinning or producing electricity like it’s taking in steam and all but it’s not spinning or like doing anything only one of the 2 sets of turbines are working

and even the one that is working is only making 0.25 electricity not the full amount it’s supposed to

If you do only natural gas, you don't need to spend ±15 MMF/S to run the power plant pumps , but you could do 2 coal fired power plants to make a total of 800 liters of hot water/s and it would be much easier 👍

It's me again am having to wait for the distilled water cuz I don't have any stored 😐😐

Me again is it ok if i put the natural gas wells 14 per row and there is 3 rows

The puping on the natiral gas sytem is so complex D:

what the hel

Note: UA-cam broke these instructions sadly just make out what you can You can fix this by first making 5 gearbox factory’s for each one you need a couple thousand each crank shaft when it’s sold it sells for 770 btw this produces some pollution Design: Iron drill x 5 -> electric smelter x4 -> bar maker x1 for each electric smelter-> iron + coal-> blast furnace -> steel. Go down under the coal step Coal drill -> coal -> blast furnace Steel T> roller-> iron rod --------craft assembler -> crank shaft 770$. Note: make sure the gears go into the left input and rods go into the right input . \/. / \ . Press-> steel plat -> roller -> gear J Now you have tons of cash after you built the 5 gearbox factory’s and send all of the crank shafts to the same sell zone I’m also just gonna assume you have enough power for this and the rest Research: Water pump 1/2 2 is recommended-> research 2 if you have it unlocked each needs power just agin I recommend using water pump 2 cuz more water output and I recommend building 10-15 of these research factory’s it After afking for a bit you now have enough research and cash for scrubbers so get to work Scrubber Design X20 Water pump2 -> scrubber use 1 for each water pump 2 -> residue -> golden storage x1-2 Now you have fixed all your pollution problems in 3 days good job now just wait a while for the pollution to go away and if it keeps going up build more water pump 2 with scrubbers connect to golden storage and add another golden storeage

Its easy if u know how it works its js instead of the distilled water that get heated in the coal plant, is now heated with the gasburners🤷

@ian_vl you just listed 1 out of the 100 things he changed

@@AceInTokyo whats hard abt making this?

2 hpt 5 lpt

​@@NunungRiani is that how you can get the max ammount of powrer out of one whole turbine?

@@NoPlease-f5w no its for to run 2 turbine per heat exchanger

Bro​@@NunungRiani

Its very simple. Every touch an old light bulb after its been on for a few minutes, very hot right? Thats because the electricity runs through a metal wire inside the lightbulb which causes it to get hot and glow, therefore producing light and heat. Its the same idea and execution with an electric water heater. You have the electricity heat up the boiler, similar to how coal would, and then you just give it water to heat. Hope this explains things :)

@void_xd430 tysm I will try it

@@void_xd430 at the end it only required a transformer, so I don't find it profitable

I don't know what you're talking about.

like instead of connecting red to red green to green blue to blue yellow to yellow you just connected the blue one and connected them all once

You just have to push the pole base and connect it to another pole base

@@benlevy5342 click on the pole base, then shift click on another pole base

How i can do on mobile?

Does it still work for 1 turbine

​@@Random_roblox_stuff1 turbine is very little for me, my production consumes 720 MMF/S but I'm already developing a 600 MMF/S version 🤫

@@evertechsanbox1630 oh alright, goodluck! (Also can i maybe help in the video, im also pretty good at industrialist)

Thanks, I'll text you if I need to

@@evertechsanbox1630 wait but does it still work for 1 turbine for someone like me it would be enough power

2

Id love to know how to control the coal power plant

600mmf/s gas power plant

gas powerplant

Hydrogen power plant!

2 hpt 5 lpt

И что?

Типа богатый а ума не хватило как станцией управлять😢

@@stendoff2861 Я смог выработать только 165-170 mmf/s

@@_CHEREPAXA_ пачму😨

@@stendoff2861 Сам не знаю, но микрочипы отменные делаю! 8x64x за 5 миллионов каждые 14 минут по 14 штук делаю если что. И электростанция на рафинированном дизеле работает и выдаёт 180 mmf/s

So you chain two heat exchanger meaning that the used water goes to the second heat exchanger(doesnt work anymore maybe) so get 2 turbine per heat exchanger 2 hpt 5 lpt 1 condenser 2 polisher and 1 cooling tower

Where is it(pls link)?

note, you can now use distilled water to make scrubbers 2x more efficent