Відео

Thanks. Did mine with a donor rack from a civic with half my mileage. 103k vs 210k I had some trouble spots: Cover drive away with card board as this job messy. Had to use castle nut at top of the rod eye bolt to serve as 5lb sledge hammer strike surface and not marr up the bolt end. Using wood and soft metal not adequate for my 2009. It was super stuck. Had to wire wheel tie rod bolts(was rusty/dirty) as the castle nut must be very easy to move the whole distance or you can not torque it during reassembly. Don't install tie rod ends backwards or they rub wheel at half turn. I found out the hard way. 24 and 19mm wrenches needed for counter torque. Complete final torque once assembled through eyebolt and castle nut secured. Buy new OEM hose o-rings. Buy new high pressure hose Use Jack to remove sub frame there are just too many things to do with it staying on the car. Lower motor mount bolts/threads at reassembly gave me issues. Only remove the bolts when the subframe is fully attached and seated. The threads are very sensitive and the clearances are small. Mark spline on steering wheel inside car all the way up to the upper piece. As mine fell out and had to realign with trial and error.

Stay away castrol oil its no good

3:55 PVC valve 😂

Thanks

My car doesnt turn over and start the engine. I bought new battery n still

Will a open pcv valve cause all 4 o2 sensors to malfunctioning causing major misfire

I have Australian 2002 Ford Fairlane Ghia V8 (similar to Crown Vic in USA). Starts ok but has rough idle (shakes) and uses excessive fuel. Have replaced plugs, coils, fuel pump and inline filters so far. Also have added injector cleaner into tank and run 98 octane fuel in it. Still have hesitation on acceleration and bad economy problem. No CEL showing. Do you think I should replace the injectors? Have 268,000kms on odometer.

He forgot alot of stuff 😭

Most stories i get that lead me to look at somebodys car, result in finding the cables arent connected clean and tight at the battery posts. After that check of twisting, i go to their alt belt, and inspect visible ground straps. Body/frame, head or block, head to firewall, what have you. Its usually shoddy job by the last person who touched the battery and 1/2 ast it.

My vechile blow light grey smoke when crank then the smoke goes away. Will this be because of the pcv valve?

Another solid video, Bro. Just straight to the point with everything! We specifically produce LEDs for auto. Can we invite you as a collaborator to do a review? If so,How can we connect with you?

How do you know it’s not a bad fuel pump?

Great video until you put the 22R engine at the end. They are a rock of an engine. Solid as they come.

Does bad spark plug cause low engine oil my car plug is bad its burn 500ML engine oil

All these sensors have the same symptoms it drives me crazy as a woman and I do my own mechanical work.

Pat Whitworth

Is that valve have anything to do with safe mode engine problem

Take a shot every time he says, "ground strap".

Question: Is it necessary to have a strap ground, or can a normal heavy gauge copper wire be used as a replacement? thank you!

Specially at 60 miles per hour 🤓☝️

sixty miles per hour

AI is crazy.

Hello, I have a 2015 Honda Odyssey and the problem is with the air conditioning. The air is a little cold. Please help.

Scotty

Fun game: take a drink every time he says “60 miles per hour”

This video probably gonna blow up 2 years later.

my car goes in reverse but feels like neutral in drive , revs but goes no where just really slow, gears not showing on dash but car starts.

You should always clean it before you put a new piston in it.

Thank you for sharing this valuable information. It is very helpful I am this problem with chevy Traverse.

You have the best video on this. And my biggest symptom when I took it to the place was not just a check engine light, but it was the fact that every time I went to get gas it was like I couldn’t start my car. Nobody else was listing that or nor was it listed on Google when I put in to see about having a hard time starting the car specifically after reviewing. Refueling. The first time I had, the problem was right after refueling.

The majority of problems were with early run 2016 and 2017 models. The 2018 onward models improved greatly with the 2020 to current a pretty reliable car overall

I've a corsa model 99 have replaced fuel pump, fuel filter, injectors, coil but stilliss firing dnt know what to do next 😮

The video is incorrect in inconsistent in how terms are used to describe and illustrate problem cause and effect pertaining to the many different types of circuits in modern vehicle electrical design. What follows is a clarification: 1) The head light ground currents do not return through an equipotential ground strap, they return through the harness ground wires back to the battery negative terminal. Usually through a ground splice power point or junction. External lighting loads, like a brake light, that use the body to conduct ground return currents back to the battery, will do so via a body to battery negative return wire (like an 8 AWG stranded copper cable) that will go directly from the body ground bolt, near the battery, to the battery negative, it is considered a ground connection and not an equipotential ground strap. An equipotential ground strap like between the body and the hood, common to see a tinned braided strap, is just to keep the hood and the body at the same electrical potential, and not to return load currents. 2) A bad starter ground, block ground, which here again is a dedicated ground connection to return starting current directly to the battery negative and not an equipotential strap, can have a high resistance which will not disrupt flow of voltage to the starter, as stated in the video, the faulty connection under load will have high electrical resistance will limit the flow of current. 3) A dead battery will not cause the same symptoms of a bad block ground. With a bad block ground you will see electrical loads activate upon key on, with the engine a no start. A dead battery, a completely discharged battery, will not activate any loads at key on, the car will be dead. 4) Interior lights can return currents through the body to battery negative return wire if they use the body as ground. Here again a the body to battery ground wire is usually not the problem. The problem is a bad ground connection between the interior lighting system and the body, usually a bolted or screw connection which is made in close proximity to the lighting loads. 5) A battery instrument cluster alert symbol represents a failure in the battery charging system. 6) A battery that is not being charged is a problem in the charging system and not an equipotential ground strap. The battery is being charged from the alternator output (red wire) and the block ground (black wire) which both terminate directly at the battery. The video shows a strap between the frame and the case of a transaxle which a equipotential strap and has nothing to do with the charging system. 7) Measuring battery voltage with a DMM directly at the battery posts with engine off key off will give you the battery terminal voltage loaded by vehicle sleep current events, it has nothing to do with a equipotential ground strap. Let me know if you think I missed anything.

Thank you so much for the info. My own gearbox make noise when I start the car and I can't run above 30kph without it shooting

Explanation explaining location! Great video

Yes try adding transmission fluid to the engine, I had a 2018 Malibu it would shut off when sitting at a traffic like, if your fluid is low this will continue to happen when I added fluid to my car it never shut off again..

I'm wondering if this is why my alternator gauge flickers when my blicker is on.

Why does my Impala stalls after a complete tuneup . It only stalls at stop light . But it runs fine on the highway .

Why My aux fan keeps running when i turn on my ac?

Just did this oil in my 2016. I used Mobil 1 oil filter. 62429 miles

In the case of Mazda CX-3, bad catalytic converters can also cause a driver side floor to get a little hot. It happened to me recently, and I'm now in the process of getting it replaced.

Thoughs 6 things to look for were so helpful. Thankd

I have a 2011 ford bantam rocam only when its hot it will smoke white blue and when starting.when cold there is no problem i thought of this valve can it be the problem?

GOD BLESS YOU AND YOUR FAMILY IN THE NAME OF JESUS CHRIST FOR MAKING THIS VIDEO 🎉

Dude, you rock for this. I just replaced the regulator in my mom’s 2014 Cruze with your video!

Trans is slipping in 3rd gear. 1st and 2nd are good and have no lost in pressure so I’m not sure why it’s doing it in 3rd. No cel codes, all shift solenoids tested good and the temp sensor. Even changed the filter and fluid as a last resort. So I have to replace the TC now?

Hi I have a bad solenoid bank2 I broke the electric connector but it still crank up and my check engine light is on

2008 dodge charger starts but after driving it and turning it off it’s silent won’t start i have tried everything please help 4:57

What a stupid fucken place to put something 😂

Very helpful this video Thanks so much.