Відео

Is this adiabatic cooling system

A plus! Thank you! A gentleman and a scholar.

why you didn't use the W terminal ??

Compressor B configuration switch mismatch alarm how to clear this issue 30xa chiller

Bro

Can you give your number if you adr working in saudi

Location?

Do you repair that? It looks like it needs rectification and new set of screws? Thanks for the videos!

Boss what is the problem of override status?

Hi

Your contact number

Esse equipamento estava pressurizado? Não vir o recolhimento de fluído apenas o fechamento das Válvulas! Parabéns segue sendo o melhor passo a passo do UA-cam.

I have problem with Carlyle A/C Compressor,when the system running for a hour we got Low Suction Pressure Alarm, can you please explaint to me what the problem and troubleshooting this problem Sir ? thank for replying my question

Please tell me the exact location

Number do please

Where it is available

Where’s the location

Can you tell me location

Straight up yorking it

Hi where are you now . one question. How to check screw clearance.

Good work 👏👍

What size pipe is this ?

Why you didn't filter replacement before vacuum?

Small size wires from motor winding temperature sensor

Small wires for Motor temperature sensor

😮😮😮

Wrong producer to replaced the bearing 😡

Thank you, sir. Im having an issue with 24v fuse keep blowing, making the board not have alarm code 31. What could cause this I checked all the safety switches etc.. no shorts were found maybe the board is defective and needs a replacement?

The reason is the high motor temperature

Please Upload Füll video explain control waring refrirnt cycal

Consejo para retirar el motor coloca dos esparragos sin la cabeza torks para que el bobinado salga parejo y no se lastime😊

Normal winding temperature ethre aan?

Bueno días. Cuanto cobran por ese trabako

Good 👍👍

❤❤❤

Круто, а можно описание замены фильтров на чиллере carrier 30hxc190a0632

Cannot understand Malayalam but still understood the video. Thanks 🙏🏼👍👌

❤❤❤

Super 👌

Hi, can the motor housing come out by itself without the windings?

Nice Work Broii.. 👍

Thank cheettaa

Then after 👍 ok or not

I am skeptical about the value of filling with water. For the bend radius shown in the video, you may have achieved equally satisfactory results without any filling whatsoever. Water exerts equal pressure in all directions, so it would make it significantly more difficult to bend around the mandrel. Also, any small leak would make it completely ineffective. For small bend radii, I think that using sand or salt would be better.

👍👍👍

😊👍👍👍

ua-cam.com/video/kEH_vrx_qc4/v-deo.htmlsi=JmQ6scpCVlCBa4m4

ua-cam.com/video/kEH_vrx_qc4/v-deo.htmlsi=JmQ6scpCVlCBa4m4

👏👏👏👍👍👍

👍👍