- 416
- 130 216
Isydia Vibes (Zee)
Canada
Приєднався 12 тра 2015
This channel about our lifestyle and the wacky adventures we embark on with our car, motorcycle, RV and truck
My personal website [ isydia.com ]. Welcome to my world and enjoy your visit.
My personal website [ isydia.com ]. Welcome to my world and enjoy your visit.
The Way We Were
The way we were
Been together since high school and still going strong.
What's the secret?
We see each other before anything else.
We see each other before society, family, culture values, religions...etc. For us, basically, we come first, before anything.
Been together since high school and still going strong.
What's the secret?
We see each other before anything else.
We see each other before society, family, culture values, religions...etc. For us, basically, we come first, before anything.
Переглядів: 517
Відео
The Last Of Us Part I
Переглядів 23 місяці тому
The Last Of Us Part-1 played on Steam. The difficulty level is Grounded and resources are moderate.
Couples jokes 🤣
Переглядів 162 роки тому
We both Google jokes and say them to one another and laugh our ass off 🤣
The quest to find DEF at the pump in Canada
Переглядів 1102 роки тому
The only DEF (Diesel Exhaust Fluid) option we were able to find was in jugs with twice the cost than the one at the pump. In USA this rarely happens. However, in Canada it's more often. Always fuel in USA before crossing back into Canada!
Time Lapse downtown Winnipeg
Переглядів 442 роки тому
Time lapse from my apartment window showing Winnipeg downtown sun-rise. Near the end the clouds and the orange sun is so beautiful.
Atari new release Centrpede on Stadia
Переглядів 482 роки тому
Playing Atari Centrpede new release on Stadia and it ROCKS 💕
Trip to California 3 of 5
Переглядів 212 роки тому
From 2-October 2019 to 7-October-2019, video 3 of 5
Blizzard, shut down at Flying J in Balgonie Saskatchewan.
Переглядів 2152 роки тому
Blizzard, shut down at Flying J in Balgonie Saskatchewan.
Getting my bike out of storage for a ride
Переглядів 162 роки тому
Getting my bike out of storage for a ride
I drove a truck for 27 years,,,, and No One has explain the Cobra 29 functions like you just did!! Great job driver! 73s and great video.
Get back together again.
Aren't you just the cutest lil dude. 😎
mic gain should be all the way up max
WHEN YOU WILL UPLOAD THE VIDEO!?
Is the antenna grounded?
The antenna hookup kit to the truck body includes a plastic washer to prevent it from touching the chassis of the truck.
Valuable information on how to adjust your CB radio and antennas , thank you.
You're welcome
Great info Thanks Driver
I can’t get my antenna light to go off
This means you got a break in your wiring from the back of your radio all the way to your antenna. You need to trace it. I would first start with the connector from the antenna to the chassis. Make sure you are not shorting the connection and the plastic washer/connectors are in the right order. If that checks out see if you don't have a break in the cable snaking through the door hinges to the radio. Hope that helps
This is a great video and I appreciate it but I have a question I have a brand new coax cable I have a brand new Wilson 2000 antenna everything is hooked up correctly but my red light keeps coming on the radio for the internal like you showed in your video I don’t know why Mike’s coming on everything is brand new and hooked up correctly would you have any reason to why
The red-light means there is a short in your antenna connection. If you are sure the coax-cable is not looped in a coil and not nicked/shorted and all connections are OK, then the most likely culprit is the hookup of the external antenna to your truck (where the coax hooks up to the external-antenna). There is a plastic washer for insulation that comes with the connector. I’d look there first. The second thing that comes to mind is the antenna wire is not touching the base (i.e. your radio does not see the antenna). Let me know if you have questions.
To check SWRs you doit with a external antenna meter. You adjust the antennas ti calibrations.. the fact that you think doing this on the radio is the right is not its correct.. I you install a bigger radio your SWR are up the sky.🤷🏽 Just saying
Great video..I learned a lot watching this..💯
Real good looking radio right there
If my antenna is glowing red when pressed how do I know what the problem is? I've been messing with the antenna all day and nothing has changed
How much power are you putting out lol, or did your antenna catch lightning 🤣
@@Isydia lol dude idk I know nothing about these things honestly
@@Isydia I finally found a good position for my antenna I think I press the mic and it blinks then goes off
@@Isydia apparently I blew the speaker somehow had to get an exchange
No one clicked on this video to see the deer escape death😤
What if the truck comes with internal atenaas
Shorten the video
You did not understood how SWR and calibration of SWR meter works! Also antenna is not going to be calibrated but adjusted/tunned! Calibration of measurement (ie.) is comparison with ethalon… When you set Cal on channel 1 to arrow on meter then you are ready to measure SWR on THIS channel 1! When you do the same Cal setting on channel 40 then setting changed (even just small change) on channel 1 and it is no longer valid for channel 1! Simply you have to make Cal setting on channel where you are going to measure SWR each time! So set ch1, make Cal set then switch to SWR and measure SWR when mike keyed. Then switch to ch19 then re-Cal to the setpoint, switch to SWR and measure SWR on ch19. Then redo on ch40. Always you have to re-Cal the setpoint of the SWR meter in Cal position… Good luck.
Why are you people talking about channel 19? Check one then check 40 once they are tuned, the values are close, then you can look at the midpoint, channel 20, to see how low your SWR is in the middle. As most people are using channel 19 for traveling you could look at that instead of 20. Being close together it doesn’t matter much.
Stay just like that ok
Lol, yeah, I think I'll do that for better reception 🤣
That rf button should be at max to bring in that receive did you know that ?
As I am nosy, yes. I want to hear the most information I can. If I don’t want to listen to you I will turn the RF gain down until you disappear or I will shut the radio off.
@@robertmanning5212 this is why they have squelch buttons
I feel like the slowdown for traffic was the mvp here *Construction
Was told in 🚛 trucking school to hit them! That would be hard but, necessary. Hit 2 with Taxi. One with car🥺
Seriously you couldn’t have cut 90% of the beginning out before submitting it
Theirs an edit function on UA-cam
LUCKY DEER !! I HAD DEER ALERTS ON MY CARS, LIVED IN NORTHERN ILLINOIS ( ROCKFORD/ ROCHELLE/DEKALB) DROVE ALOT. MY FRIEND DROVE 18 & A DEER RAN RIGHT BETWEEN HER PETE & TRAILER WHAT A MESS.
How is that possible
the construction saved its life
Dusk
Saw you
Saw you
Just because u like to waste time doesn't give u the right to waste our time. Video could have been 5sec
So you watched the whole thing and missed it at 2:13 😁
Driving on Interstate 57 south in downstate Illinois is like playing Russian deer roulette. Especially at night or dusk.
Dame waste of 2 minutes of my life
Oh deer!
Not worth watching..
I do
Nerves of steel. You hardly even flinched.
Rf gain is recieve,crank it wide open on the highway but turn it down in trk stops..mic gain is the sentivity of mic but you should almost be eating it when you speak anyways..When you calibrate,re do same process for each ch not 1 and 40 at same time.....Your antenna is a base shaft,load coil,top mast and whip..Oh its wilson not nelson antenna nor are they the best,top load is better for range,those are mid load... Doing the calibrating does nothing for antenna,its setting radio up to see if ant is long or short...When you do your antenna adjustments,go back and do the calibrations again and test 1/40 to see if you need to adjust antenna anymore..
Underrated comment. This is the valuable information!
Hi Isydia Vibes, could I feature this clip on my channel? Where did this happen? Thanks
Sure you can use any of my clips. The exact location you can put the gps coordinates you see from my dash cam in google maps and it will show you.
@@Isydia Thanks and hit subscribe
Amazed to see there isn't a single light at road,
No lights in the middle of nowhere's
IT'S COUNTRY
Great video!
I've hit 3 this week. Two with the front bumper of the International and one that ran under the trailer.
Clickbait bs fu
I DONT MAKE ANY CUTS. I JUST RAISE OR LOWER THE WHIP IN TO THE COIL SECTION AS PER THE INSTRUCTIONS.
The wire whip is usually longer then it needs to be on these types of antennas. If you have room for improvement, channel 40 is higher then channel 1, you can continue to lower channel 40 by trimming the whip. Cut with bolt cutters or hacksaw. With bolt cutters beware of the metal shooting off at someone. Pick up cut part and discard. If you cut too much off, raise the whip, snug it, then test it again. When you are happy with the results snug the loose hex nut, using locktite. Then snug the other, also using locktite. DO NOT OVERTIGHTEN THE HEX SCREWS. They WILL strip. Throw away the hex tool they give you to work with as they are garbage and don’t deserve to be with your other tools.
8 score for tha dive 🏆
I used to live in that area. Yeah Deer are a thing. lol
Mateee when you will upload the video? ;)
Trucking - On the road again ....
I use a big Italian poweramp / CB booster with auto tunner so no antenna adjustments are needed.
Not helpful
@@robertmanning5212 Why not
I wanted to hear the rest of that Hank Williams song, as well as your informative video.
Guys like that I like to see in the ditch upside down asking for help.And I'd drive right by.