Відео

where's the speed limiter on this?

where's the speed limiter located on this? 🤔

I don’t have a dial on mine it’s push botton Amana washer

Guys, don't do this. This won't work, and you will most likely end up frying your main control board. If you want to bypass the lid on a belt drive machine, just take off the lid striker off the lid, put it inside the lid switch, and....... it works! No frying any control boards necessary doing this method

What type of magnet can i use...i dont have one like that

so we all have same problem and no solution.POS

Might won’t turn on the light for nothing 😭

Thank you! First video that came up and it's exactly what I needed. Simple, sweet and short.

Do you REALLY think you are funny?

Thanks!

Perfect fix! Thanks!🖐🖐🖐🖐🇨🇱

To much talking go str8 to the point .

Didn't work

Not one video on what to do when your washer locks with your clothes inside

Thank you! Fixed it!

💯 Thank you, this worked immediately. Was down for a few days.

Does washer have to be empty for calibration

I used calibration reset and then unplugged machine for 10secs. Works like new! Thank you!

Wow! Can't believe it did work for me🥹👌 Thank you for your video!🙏🏼😊

Dorsnt work. Old school washers are better than these new bs pos

I despise this sense fill washer and feel I have been screwed out of my money for this crappy machine!

I did this and the light is still flashing. I have a Maytag

Worthless video F.U.

Video does not correspond with the automated speech.

I'm trying to enter recalibration or diagnostic mode, but it's blinking on the first light (sending fill) and the other lights are solid on. I tried spinning the dial as shown at multiple different speeds.

Watch the video don't follow the audio!!!!!

But how do you start a cycle ?

My washer wont start 😞

Whole purpose of the video was to see the bypass. Waste of time

This video is garbage!!

Why oils a Cabrio top load washer stop counting down at 17 in Spin and just continue to spin?

I just tried this, and it works like a charm! Thanks!

Smoke crystal meth and GET 'ER DONE and lose weight

I'll try tonight, hopefully my arm won't feel like it's going to fall off.

AI nonsense.

Make sure to remove disc brake protectors in between to easily slide the front wheel disc brake else it will make the front tire not align right

Man, it took me almost an hour to get the skewer right. The was a piece of plastic mold inside the hole on the opposite side. I kept having to jam the skewer in to pop it out. Finally got it though. They need to retrain their inspectors lol!

Thanks for wasting my time with a misleading title

Just get a Japanese WASHER. DAMN ALL THESE CODES. LOL BETTER HURRY BEFORE THE TERRIFFS

Worked great!

Thank you! It worked. Well my machine isn’t functioning right yet. It didn’t take 20 times, just 9 😂 I was turning too quickly. When I turn a just bit slower, with a short pause at each reversal, that’s when the lights came on. - Have a pen and paper to right down which lights turn on when you do the code part.

Thanks!!

Yayyyy mine worked lol 😂

It runs the test but the lock didn’t lock and after test was complete all lights shut off and nothing. Is that a lock problem

No F2?

My 6 lights aren't under the control knob, but on the side and at after order lights.I'll still try this.

Ola...do u happen to hav a mssge app to mssg w u? Tgram?

METHod meets madness cause you got to be high to think this was a good video

Saludos desde Guatemala, perdone en que parte tienen las Crosley el filtro. Gracias

made no sense at all