Відео

Didn't work. After second hold snd pressing fob it doesnt beep beep beep like in the video. None of these videos have worked. Setting this unit up has been a nightmare.

Did exactly this and now my door only opens. I have to manually crank it closed..

Thank you 😊

Is this motor from Italy 🇮🇹?❤

How do you take the cover off to access underneath

Mines stuck in holiday mode and remote isn’t working? Any idea how to overcome this? 🤦🏼‍♂️

That is an excellent instruction video. I recently bought two of these remote controls and then tried to follow the instructions provided by the supplier, which were nothing like shown on this video. After numerous attempts and much frustration, all my efforts were unsuccessful. I then found this UA-cam video and, by following these simple instructions, both remote controls were programmed in about 10 seconds. Wonderful. Thanks heaps!

Thanks for this video 👍

So simple once we'd seen your video - the written instructions were IMPOSSIBLE to understand! Thank you :)

Thanks, the instructions that came with the remote were in double-dutch. Once I'd seen your video the longest task was finding a paper clip.

THANK YOU SO MUCH !

My slat sensor has been eating batteries now not working can a replacement be got cheers.

And what do u do if the remote is not working

Hi. Do you think you can show how to connect up a smart opener device like a meross? I want to be able to use google assistant to open it.

any idea how to cancel holiday mode if your remote has died inbetween?

How do I reset my control panel, mine came with the garage door, not sure if this information will help: Teleco automation/code number TVPRP868N09/ series TVLink RS868. any help would be appreciated Thank you Peter

Hi what’s the radio code frequency for the remotes 433mh

Do you know of any where that can come out and service these teleco units

when i press start the gate won't move, but the set works fine, how is that? also the engine get the signal from the reomte control but stil doesn't work

i did it! the engine is getting the signal but the gate won't open! when i press set the gate open and close fine :(

You solved a problem for me, thanks. I did not understand that it was necessary to proceed with cloning near the gate ;-)

Scratch that - for other folk, I had the transmitter open and the big button INSIDE is NOT the normal on off button you press on the outside. Close the transmitter up, follow the video and all worked for me (d'oh)

I do this but then when I press the transmitter button, hoping to open the door, the receiver just emits a long (5 seconds) beep and the door stays put. The open and close buttons on the receiver/controller still work though.