Відео

Our Beckett / Coleman. Has stopped working right. Been stuck in lockout. I finally took a closer look and noticed the screw / nipple in the clean out was leaking small amount. I loosened and tightened and think it stopped. Wondering how am I supposed to clean out the clean out hahah. Also wondering why it’s doing this ? Any advice appreciated

What degrees bushing did u use ?

IF THE WIRE IS 12 /2 ON A 15 AMP BREAKER AND IS WORKING FOR LIGHTS ONLY AND THERES ONLY 8 TO 10 LIGHTS CONECTED TO THAT BREAKER WITH OUT SERVICING ANYTHING ELSE THERE'S NO FIRE HAZARD GET REAL

That looks like old 12 nm before the yellow jacket

Why pull new wire, just put it on a 15 amp breaker

Yeah my 2016 dually just started this after we replaced the drag link and inn/outer tie rods and sway bar end links and front end alignment. Just wondering what it could be. Didn’t have the issue b4 all this was recommended

What about the post in the corner.

What about when the romex runs through insulation? It cant shed heat in that situation.

yeah but it sucks for the next plumber who comes out to replace somethint

Eehhh, it’s fine.

Same thing happened to mine.

These bushings are great for destroying axle dust seals and inner oil seals

Same exact thing happened to my arkfeld pro. I came here to see if others had the same issue before looking for warranty service, thanks for posting the video!

Those inserts are not the amount of caster or camber it has. They provide up to 2 degrees of change depending on how oriented and how much offset different ones provide by moving the upper ball joint geometry. Base caster and camber are based on the front end design. These trucks once had fully threaded bolts, instead of shouldered bolts, that held the track bar to the frame. This resulted in the track bar bracket getting loose at the frame. Your shocks look very old. Take the easy end loose compress it and see if the hydraulics are wore out.

Did it work?

Hey brother did that work for you? I have replaced a lot of things and still have the shacking

Step away from the spray paint.

We hired an electrician to set up our plug and panel for this. Works great. You can tell when elec is back on if main box is reading numbers. The panel was altered with a safety switch so the main breaker can't be engaged when in use for generator. Although running almost entire house is expensive it is a trade off for convenience and having heat in the cold. Michigan loses power a lot. Dte. So we felt it was a good investment.

The longest running one I have is 20 years on my water heater.. held up so far..

FYI, the video displays sideways. Even on my iPad, if I tip it to one side, the display is all wrong.