Відео

Какие колеги? Захерачил посадочное место

شكرا لكم

What year make of car

They do have tools to take those bearings out so you don't have to grind those bearings out. You can order the tool online.

انت نفر واجد كويس

Excellent, thanks

ما شاء الله تبارك الرحمن

До упора затягивай. И не забудь контрить

Tie strap on drain plug was an overkill

Besser Gewinde und Rotierende Anlageflächen mit Druckfestem Fett einschmieren 😅😅 geht leichter 😅 Werkzeug hält länger😅

Cual es el Torque que se aplica ??? Cómo queda el ajuste corona- piñón ??? ???

good

Which country bro

Perfect example of what not to do... love how you destroyed the case from the pounding of that chisel

Did not lube caliper slides or replace caliper brackets even though he had new ones with the new brake pads. Just machine and pad slap.

Hand tight filter

Thats more work than it should be

Never used a ratchet drill when working on the transmission filter as a mechanic I do not this recommended.

UZ

اعتقد نيسان

c'est très bien ! mais fais quand-même 3 tours de vilebrequin pour t'assurer que tes repères se retrouvent bien en face

Good job!

ну еще бы пару раз на герметик вклеили хуле ей будет:)

First show how you removed the hub..😂🤣😂

install=uninstall or its only reverse video? 🙂

Very clean old water pump

2uz

Я понял только то что человек таким образом решил слить антифриз!😂

предварительно слить нельзя было?)

regular grease will kill your brake fluid and piston seal that is made from rubber,have to use silicone grease

Mountain Dew

Grasa en el piston de freno este es un criminal

Amateur mechanic

i have never seen press on hub bearing remove from the front unless it was a bolt on from the back .

Nothing new here, people been doing this for years

❤❤❤❤❤❤

Didn't see you lubricate the sliders or use a torque wrench these are just two of the basics .....

You could also use a scan tool to access the service mode and retract it. Another option is to put 12volts on that motor

I mean, sure, the manufacturer has torque specs for a reason, but hey, you have the impact, so just run them down. No problem.

Whats a break hub?

Видео для принцесс которые боятся замарать ручки 😂

You didn't grease the retainers which is why those pads are tilting. You should have cleaned them out and greased them.

Zip tie is genius, no reason to punch the filter though. If you're that worried about getting oily or dripping, get a rag/gloves.

Его нужно выкинуть а не протачивать

Still got oil on his hands

Too bad he can’t spell

That already Looks too thin for any car.

No. Use a proper press. You can also freeze the new joint to shrink it whilst heating up the receiving member to expand it. It helps a lot.

No axle nut torque spec?😂

Ok. M7y buena erramienta ,pero los que yo he desarmado salen por el otro lado y llevan un seguro , tipo anillo , la otra es que la cuna del balero queda pegada al muñon y hay que retirarla para poder instalarla de nuevo , o se cambia tambien el muñon . Queremos ver como lo instala de nuevo