![Joe's Useful Vids](/img/default-banner.jpg)
- 4
- 18 534
Joe's Useful Vids
Приєднався 5 сер 2011
Відео
How To Clean Textured Interior Car Plastic
Переглядів 624Рік тому
Just a handy dandy little tip for you. Clean that tricky plastic cheap! The product can be bought at supermarkets or hardware stores. Also called Eraser Sponge, Magic Sponge ect. Comes in bricks that can be broken apart. Hopefully this saves someone time!
Nabco Proportioning Valve Disassembly
Переглядів 135Рік тому
Nabco Proportioning Valve Car: 1997 Nissan Lucino VZ-R 3 door hatchback. Might be the same part in other disk brake ABS models; sentra, pulsar, almera. Nissan Part Number: 464009E000 Link to brake line diagram: nissan.epc-data.com/pulsar/jn15/3517-sr16ve/trans/462/?full=462A_002 Not an expert this is just one of those fiddly things I worked out myself so if there's a better way or more informat...
Fisher and Paykel Fridge Leaking
Переглядів 17 тис.2 роки тому
Fridge freezer model: E372B Video description: In this video I show how I solved an issue with my fridge that was causing a puddle to form underneath it. I show how I got access to the back panel of the freezer and I also briefly cover how to remove the sliders for the draws. Apologies for the lack of editing, I realise I drag on a bit here and there but I just felt I needed to make a video as ...
Thank you
Thanks made things a lot easier after watching your video
Good video. I too have this f&p fountain fridge. My fridge had overflow and a dry sump in the back. I couldn't get any purchase to remove the side panels. Even trying the defrosting scraper for leverage. So fully defrosted the fridge freezer and then poured very hotyywater into the bottom of the back panel of the freezer at the head of the overflow tube. It overflowed into the freezer compartment and then settled into a gurgle as the rear sump tray filled. Your problem, as mine was, may simply be a stubborn chip of ice. This first test could save a lot of mucking about with panels and save your fingernails!
Legend, was good to see the bottom side panels come off before attacking this job, was worried I was going to break something
Works on a RF522BRPW6. I did find out the hard way when removing the back panel that the fins are thin and very sharp. The drain area was full of ice and it took 20+ minutes with a hair dryer to thaw that out. It still wasn't draining until a bit of wire jiggled about did the trick. We had previously had a slightly smaller model F&P and the little catch on the bottom of the door that assisted with closing was prone to breakage, and we had problems with the back of the fridge icing up. It's the same catch on this model but they must have improved the material because we have only had to replace one. Listen for the doors pulling fully closed to seal - a cracking noise after you close them. The fridge needs to be properly levelled as the frame is flexible and this prevents the doors from fully closing and sealing.
Ahh someone else with the F&P waterfall. I have tomorrow’s project sorted. Thx heaps.
Your a legend Joe, worked a treat, thank you. Even broke the same clips you did ha ha. I'll aim to get the back off in one piece by getting the fingers a little further in to get a hold on both, should there be a next time...
Another big thanks! Just did exactly as you showed… would have been impossible without this guide. All re-assembled and chilling, hope it’s fixed.
Thanks so much for this video - awesome stuff!
Many thanks Joe, this was a great help. We couldn't manage to get the side panels off, so got a bit of curtain wire and fed it up from the bottom and water quickly flowed.
You are amazing thank you so much I’ve just spent Sunday afternoon following your video and save myself a few hundred dollars in the process. I’ll have a glass of wine and cheers to you😊
Thanks mate 👍
Exactly the video I've been looking for! Thank you for showing how the side panels come off, every other video on this topic omits that part which just happens to be key to the whole fix. 5 stars ⭐
This stuff needs to be taught in schools!! I had a big blowfly blocking the hole!🤣 perfect description 👍🏽👍🏽
Excellent video Joe! Thanks so much for posting the video. Never would have figured it out myself. Can I suggest that you change the title to include "Freezer cold but fridge not cooling (accessing/replacing evaporator & fan)". I had all but given up on finding anything on UA-cam but kept searching until I found your video. Also perhaps include the other models that it applies to in your description. Mine is a E522B but it is identical. Mine had an iceberg at the top of the evaporator that blocked any air getting pulled up into the fridge section, the oposite to the problem you described. I think what happened is the freezer door was left open and frost formed on the evaporator by the fans running overtime.
choice az just what was needed thank you
Thank you, thank you, thank you. This video just saved me a day of heartache. My model is only slightly different and I would never have figured it out. Perfect!
10:10 whats that metal wire looking thing sticking all he way down to the drain? is it something we can use to unplug the blockage??
Saved us and our fridge! Very useful as advertised, thanks!
Thank you soooo much. This video is doing such great service to humanity and marriages throughout the world!
You're a lifesaver! I fix a lot of fridges but have never come across this model before. I didn't know how to get those side panels out until I saw this video. Subscribed to you, fellow kiwi by the sound of your voice?. Thank you SO much!
No wurries!
Thanks for the video, was super helpful. 👍👍👍
CORRECTED TITLE: FISHER AND PAYKEL Fridge Leaking Note that all CORPORATE {Legal} names are ALWAYS in the ALL CAPS iteration. Pay attention to detail. Make sure the brain sees what the eyes are looking at. Only a Living Soul has a name in Mixed Case Letters. ZOMBIES have eyes but cannot see - Ears and cannot hear
I cannot thank you enough, you have saved me a lot of money and difficulty getting a new fridge up the stairs of my unit. My fridge was a bit of a different model, but your instructions were still spot on. Feeling so accomplished right now!!
Terimakasih untuk berbagi kebaikannya bos
Mate, you are a deadset legend. Thank you. Saved me heaps and in the end was good fun fixing it myself. Love the accent too. 😊
Sounds like good ol no.8 kiwi to me👍🏽
Thanks for a great video. Just a couple of things 1. When removing the rails, the left hand tab lifts up, the right side tabs pushes down. A bit of wriggling is needed when replacing them 2. The bastard back panel in your video, the corners were snagging. We levered it out with car upholstery clip removers. One to hold it inwards towards the middle of the fridge and the other directly under the tab levering it up. It will pop out
Thank you very much. I’ve just fixed our fridge and feel very proud and saved some $$. Couldn’t have done it without your video.🤩🥰
Thanks for sharing.👍👍👍
Great instructions! Everything was exactly as explained and fixed the annoying leak in 30 minutes. Now my wife thinks I can fix anything!
Thanks!!!
Just realised that I'm not the first person to work this out and that there's already a few videos on UA-cam about this. So I can't claim credit for this one, dang it!
You're the only person I've heard it from, so I'm giving you credit for it - thanks, Joe! 💕
I have identical model fridge freezer f & p E series - any ideas on why lower vege fridge department bit too cold ices up my salads lol 😂 freezer was a bit frozen up but all behind freezer panel defrosted, fans working turned it off and back on but still get two beeps and led panel flashes from green to red !! Arrrgh any ideas
Any suggestions after doing all this and days later it's leaking again and drain hole in the freezer is frozen over again?
My husband has just used this fantastic video to fix our leaky fridge - great instructions, exactly what he needed. Thanks so much.
Thanks! That was a great help for fixing my Fisher and Paykel E372B.
Thank you for the great video. This is the second time this has happened to me. Another option without removing all the side and back panels is to remove the small panel in the freezer section. There are 2 screws. You will be able to see the rubber hose going down. Use a hair dryer to melt the ice. Go to the back of the fridge and undo the tray where the heating elements are. Put a towel on the compressor and put a wire into the hose to unplug it. Water will come out .
Thank you, much appreciated.
my fisher and paykel freezer evaporator cooling fan is broken. i bought this refrigerator in the year 1999. Model : Shacklock E372B. can you pls tell me, where can i find a cooling fan? currently i am using 12volt, 3.12 Watt cooling fan from local store. But performance is not good. the entire cooling system is deteriorated. Not sure whether i need to charge r134a refregerant. can you pls guide me? its a upside down refrigerator. freezer is somewhat ok, but upper part fridge not cooling. And the outside body is very hot. I can not access to condenser coil, bcz it is sealed inside.
Thanks for the comment, unfortunately I'm no expert on these appliances and I don't think I can help. But good luck! Always better to fix something if you can. Cheers.
Thanks so much for this, couldn't have done it with out you!
no joke, but thank you for breaking your clips so that we wouldn't have to this vid helped me heaps bro cheers 👌🏽
thanks mate. this was what I was looking for, could see the problem was exactly the same , but couldnt work out panel removal. Used bent nose thin pliers to get in behind those side panels instead of my fat fingers and we were golden. many thanks
Thanks for the video. It's hard to find the information about F&P reparing
Bro. That video was sick. Nailed it! How could such a tiny piece of fluff cause so much carnage?
Thank you very much Joe. I fixed our leaking fridge yesterday. I could not have done it without your video. How did people fix anything before UA-cam? You explained the really fiddly bits very well. Why are those panels so hard to remove? But your video reassured me that I was doing the right thing and that the panels wouldn't break. Much appreciated, thank you again. Brendan
Thanks for the comment, certainly took me a while to figure it out myself!
Thank you for this, is there a video that shows what happens when the fridge is warm, on the same model of fridge. Thank you
Thanks for the comment, sorry I can't really help with that issue. The problem in this video was just something I had to figure out myself so I thought I better share what I learned. Hopefully you've been able to resolve it!
I appreciate the detail you've gone into with the fiddly bits you can take for granted... great work, thanks for the tips!
Great video, Joey! You've always had a knack for giving detailed explanations and still making them easy to follow! 😊
Thanks for the informative video, Keep it up.