Відео

@@salm8010 Yes, it comes with the case.

Int he end of the video the cable is called 5V 3-pin to JST SM 3Pin Male ARGB Adapter Cable

@@79sketches I plugged into a wall charger.

@@S2KV makes sense

The cable with the yellow sticker is attached the SATA power connector which you will need to plug to the power supply if you do not want to sync to the motherboard.

@@S2KV thank you very helpful! I do want to sync to motherboard. I do not have the extension cord/ adapter at 0:38, what adapter should I get? Thank you 🙏

@@fufumccuddlypoops5502 you will need a JST cable.

Yo u could only chose either or due to the 4 pin ARGB connector that will be required to be plugged onto the motherboard directly.

As long as you have the data power cable, the connection guide can be found here www.deepcool.com/products/Cooling/fans/FC120-3-IN-1-Daisy-Chain-Performance-ARGB-Fan/2021/13582.shtml

@@rene.grondzi are you able to change the LED lighting through the switch on the case? If so and you are tying to sync through the motherboard then you may want to check your motherboard’s lighting software. The cpu usage going over 70% has nothing to do with the LED, you may want to check the usage under task manager.

@@S2KV I can change the color now but it stil flickering, and when disconnect the rgb converter, my cpu gows back down to 5-12% on idle 😅 I even tested the voltage on the RGB connector on the motherboard it gave 12V max output and on the converter it gave 5V. I'm getting so confused from this issue😅 All i can think of is that maybe the converter is the problem it creates short circuit or a resistor is burned out on the converter.

@@rene.grondzi The flickering could be caused by the pcb board, but getting support for that part now would be difficult since the company has been banned by the US government.

@@S2KV No worries , We have them here in Europe im getting a new converter. Hope this one works

@@Reachout-Revitup sure can

@@S2KV thanks!

@@DashcamDriversUS. sure

I have the same CC360 case and I'm also unable to get the case fan RGB to work.

​@@jazlaaaaaaaan i got the rgb on but fans aren't spinning, am so annoyed

Sure

@@S2KV Thanks!

I don’t have the CH560 but looking at the builds the fans are using the industry standard connectors with the 5v 3 pin argb for the LED and the standard 4 pin pwm fan connectors

If you want to disable the LED then yes, you can just leave the 4 pin pwm fan connectors that will power the fans to spin without having the LED on.

Sure

Happened in Rancho Cucamonga, CA. Young driver couldn’t handle the speed and power of the car.

@@S2KV Thank you

Sure

Sure

@@S2KV Thank you!!

Sure

@@S2KV Thanks a lot!

I have no luck, it seems like the VRR on the TV can't be disabled which maybe causing the issue. I had sent a support ticket to TCL and they confirmed that the VRR can't be disabled and asked to provide more videos of the issue. I have tried 6 different cables and didn't resolve the issue either. I have it on 60hz now and that is the only option for 4K where the screen doesn't black out when connected to the PC. Maybe for gaming consoles there are no issues running 4K 120 hz.

@@S2KV OK, thx for your response, it would be appreciated if you get any answer from TCL, please drop me a message. Thx in advance!

@@janostoth8151so TCL responded and claims that there is a part that will need to be repaired. However I’m hesitant as I’m afraid they will scratch up my screen and they will not mount back up my TV which is over 100lbs.

Sure go ahead and use the clip, this happened in Rancho Cucamonga, California

Absolutely

@@S2KV Thank you!

That street has plenty of accidents specifically that spot. It is a known accident spot, careless driers exiting that Costco parking lot. There is no center lane to exit onto as well. Either you make it through or you stop and block traffic. I already had several close calls leaving work taking that street.

Sure.

@@S2KV Thank you

That's the street I take when I go home from work everyday. I stopped going the speed limit due to these drivers just coming out of the parking lot without checking for oncoming tracking. It's a daily occurrence and I have had closer instances that barely miss me.

fr this happens to me alot and let it slide we cool

@3xb. exactly. You got to pick your battles

Sure

Thank you @@S2KV

There are clips that locks the top cover piece to the bottom piece. At the 35 second mark you can see all those plastic wedge like parts along the inside of the top cover. I used a very thin flat head screwdriver.

There doesn't look to be an option to resize.

I tried 4 different brands which claims certified, in the end it looks like I would need to disable the variable refresh rate which isn't an option. Hopefully in future software updates to the TV would allow this setting to be disabled.

I tested with PS5 an it works fine 4K 120 hz VRR. The Problem that I have is the dual output of my AVR Receiver. If I use both HDMI outputs VRR and 120hz are no more available. But that's a bug of my AVR not TV.

Germans invented cars

It's insane, I wish people were more responsible.

Sure, it happened on CA 71 southbound on ramp in Chino Hills, California.