- 12
- 45 742
Peter Breen
Приєднався 8 чер 2013
Відео
750a John Deere drill in field part 4
Переглядів 9 тис.4 роки тому
750a John Deere drill in field part 4
Calibrating the TCM on a 4600 John Deere display
Переглядів 8504 роки тому
Calibrating the TCM on a 4600 John Deere display
John Deere 750 a drill entering calibration part 3
Переглядів 1,2 тис.4 роки тому
John Deere 750 a drill entering calibration part 3
John Deere 750a drill isobus drill set up outside part 2
Переглядів 3,4 тис.4 роки тому
John Deere 750a drill isobus drill set up outside part 2
John Deere 750a isobus set up part one
Переглядів 2,3 тис.4 роки тому
John Deere 750a isobus set up part one
Creating and driving boundary’s on John Deere 6130r
Переглядів 10 тис.4 роки тому
Creating and driving boundary’s on John Deere 6130r
Could you do a video on setting up the section control?
Are you pulling a six furrow plough with a 6130R?
💩💩💩💩💩👎👎👎👎👎👎
Is it a Kverneland plow?
How is the crop looking now
Hi Peter, Good videos to get users started with the 750A drill. Just one thing to note on this video is that once you have entered the weight into the head unit after first calibration, the computer then readjusts the metering speed to correct the discrepancy between the rate achieved and the rate required. At this point if you would like to check that this has happened correctly there is the option to check the calibration with the check calibration button. You do not need to start fiddling with the manual adjuster as you suggest.
Wie viele gewichte hat der vorne drann???