Відео

@@mikebaee7731 training cycle

Thanks.

Thanks, but I'm quite rusty as it's been about 6 years since I stopped being a programmer. I just jump in and help out some friends a couple of times a year now.

Nix, enbart relativt låg egenvikt.

Jo vars funkar riktigt bra, jag som tillverkar den (Trail Grader 150 E )

​@@Malmgren828 går de att köpa en sladd av dig ?

​@@Malmgren828 går de att köpa en sladd av dig

It's 9 years since i did this welding program so im not sure but probably 6,8-7,5 m/min wirefeed volt /amp i dont remember, welding wire is 1,4mm

Det är inte helt omöjligt, ska göra några uppdateringar och förse vår skoterklubb med ett antal först bara.

Hej Fredric köpte dom på Amazon www.amazon.se/dp/B07MVBGKL3?cafId=54bcb361-e710-49bf-add4-e3aea48b266a&cafASIN=B07MVBGKL3&ref_=cm_sw_r_apan_dp_PA17WZE7BN2C3YVC9F4T

Ja det blir nog åtminstone ett snöstopp på högersidan.

Hi Paul, it's been many years since I worked on this cell so I don't remember exactly, but I think the robot handling the parts was an ABB IRB 4600-2.55m 40kg and the smaller welding robots ABB IRB 2400 or 2600.

@@Malmgren828 nice, thank you very much

Aruond 3,5- 5 mm/sec

@@Malmgren828 thanks I work with an igm robot I have a hard time to get a perfect edge at beginning of welding and ending of welding... sometimes miss a spot or over weld.... how do you do in your robot

@@helioleal8152 Im normaly use abb's search function and create an 3d search of the weld start and then seam tracking (weldguide) to avoid those problems. Some joints can be wery difficult to track so in those cases i will search both start and end and just use the heigth tracking function so i dont collide my gascup in to the workpiece.

@@Malmgren828 me too ... I have a laser camera(icam) to do joints do you have in abb as well

@@helioleal8152 I dont have a laser, im using touchsense, by wire or gascup, lasers are cheating 😉