Відео

Thank you for your kind words! The canal may have a slight internal bend or narrowing that could either be blocked by debris created during instrumentation or ledged. To unblock or recapture the canal lumen, you should: 1. Use plenty of irrigation. Start with EDTA as a chelating agent until the canal is unblocked, then switch to sodium hypochlorite. 2. Pre-bend a size 6 C-pilot hand file (VDW) or a K-File/Flexofile. 3. Advance the file slowly into the canal, carefully following its anatomy and possible curvature. Pay attention on file distortion and dispose that to avoid a file separation. Good luck and please let me know how you are getting on.

O prazer foi todo meu Dr Jose Vitor Mazaro ☺

Muito obrigada!!

Condensing osteitis is usually a reaction to chronic inflammation from a tooth with pulp issues, like decay or trauma. Treatment depends on the tooth’s condition: RCT, If the tooth has irreversible pulp damage or infection; Monitor only, If the tooth is asymptomatic and the cause has been resolved. The bone changes often heal or stabilize after treating the source of the problem.

Glad you liked it! 😊

Muito obrigada Vania!!!! Voce tambem teve um papel muito importante em minha vida e minha inspiração na periodontia!!!! Super beijo 😘

Thank you so much!!!! 😘

Thank you so much for your comment and glad to see you here. External cervical resorptions are normally associated to trauma, orthodontic treatment, periodontal problems or even to occlusion. In this case it was possibly due to the orthodontic treatment.

Thank you! I normally use Senseus FlexoFile, XP Endo Rise (FKG) or TruNatomy (Dentsply Sirona). It is important to use the Glider file before the Shaping file to prepare the curved canal with full control . Good luck!😉

You are very welcome. Glad you enjoyed it!

I use TotalFill BC Sealer HiFlow from FKG. 👍

You are very welcome. Glad you liked it! 😊

I normally use a Coarse (green) Diamond Bur - Taper Round End to drill through both Zirconia and the porcelain of the PFM crown. And then use the Carbide Burs PR-2 to go through the metal part of the PFM crown. Please remember to use lots of water when drilling through those crowns 😉

I normally use a Coarse (green) Diamond Bur - Taper Round End to drill through both Zirconia and the porcelain of the PFM crown. And then use the Carbide Burs PR-2 to go through the metal part of the PFM crown. Please remember to use lots of water when drilling through those crowns 😉

Thank you so much! So happy to hear you are enjoying the videos!!!

Thank you! 😊

Thank you!!!

Happy to hear that! I used to think the same way before the CBCT. It totally changes the way we think and approach the cases. 😊

Thank you so much! there is definitely more to come. I look forward to hearing your comments to the next ones.

Obrigada de coração!!!!

Thank you!

Glad you enjoyed. Thank you.

Thank you Cristina! That is right. Let’s try to save them!!!

Thanks so much! It means a lot coming from you!!