Відео

bravo

I can't understand a thing you're saying brother you're whispering

Lukka laanie

That is goddamn clever.

May I ask what sort of wires can your Fili Cavallin makes

0:47 how can you make a metal smithing guide and say that “silver has the highest melting point” among the 3 metals? Everybody knows that copper is the highest as it melts at 1085°C whilst silver 962°C.

Great tip!!! Thank you Hans!

I can't tell her what the hell's going on

I’d try start with fresh melt dish and when ya melt relax on the heat no need for the full jet on alow the gold to melt & come to meet in middle as a blob then just pour as 123 poured .. also don’t add so much what eva ya sprinkle on top should be borax powder

What was the compound you used to remove the scratches? The video was too fast to be able to read it. Thank you.

Hi there, I've got a question, why is my wire breaking when I pull it through the drawing board?

Thank u ❤

hey thanks for the great explanation! can you please write me down the name of the acid you are using to purify the mixture ?

Thank you sir❤

You have contaminated the metals start again or clean wit aqua Regia ! 3rd generation jewelre 35yrs hand made ! Alloy all myself . In my experience you got something in the mix !

Great written description, but can see the mold? And can we see what the product looked like when you removed it?

Hi , I like your ingot , where I buy it ? Thanks!

motiya kandore jaalne ke liye kdm kaa taka kese bnate he

Thank you for helping in my country Iraq we use kademium but this metals not good for health 🎉

Thank you

what is the carbon rod ?? is it just charcoal?

Can we make a solder with just silver and zinc? (Without copper) Results? And composition please 🙏

Very good idea. It elimanates a lot of problems and less work to finish it off. I need to make a 13 mm hollow bangle and hope this method will work. Excellent.

Please show gold solder.

I don't know what I was expecting, but that method wasn't it. Basically sorcery.

GRACIAS

Hello, what size metal should I cut for a 2mm tube?

I always did that corner with a cylinder frase but this is looking mess less and faster

The only video showing how to use potassium nitrate to clean up the gold

Neat!!

WOW! Very interesting...thank you!

What about 10% Cadmium for low melting point work.

Really great tip! Thanks! 👍🙂

Thanks for sharing this! I have been searching everywhere for how to do this but apparently wasn't using the correct search words but then stumbled upon your tutorial. I'm sure I will have other questions when I actually start to do this but this is great info and enough to get me headed in the right direction. Thank you so much! 👍🙂

Wow, I feel enlightened!😂

Pliz how to make gold 12 k ?

****

How you don't have the name of the drill like wtf.....

😘😘😘🙏🙏🙏⚘⚘⚘❤❤

Great Vid!! Did you say Bob is your uncle? I have never heard that before! Hahaha!

Great, thank you 🙏

Been going nuts with this problem. Thanks.

Hello dear red brass??

AMAZING!!!! CAN'T WAIT TO TRY THIS! THANKS FOR THE VIDEO!

Wow your a genius. Thanks 👍

Thank you, good to know

I have a pepe small rolling machine✌️ I wanted to ask no matter if my metal is soft it will not pattern metal with plates . And no matter how loose it is tightened down the handle easy than stops ? Can you help me ?

Proud to be hand makers.

Genius!

When it happens, often the cause is the gold that contains other metals or impurities. Some times the only solution is refine it with acquaregia.