Відео

Use tool "4026947077154". How much oil do you pour?

I would of welded a small bolt, then a puller myself, less messing around

Va salut , de unde sinteti de loc? am si eu o problema cu rulmentii 5-6 , puteti sa schimbati toti rulmentii ?

Pozdrav.. Koje ulje da stavim u manuelni menjac 6 brzina,Master 2.3dci,2015 godina?

Again thank you much you are my 100th subscriber!!! And thank you for sharing your videos!

Thank you for sharing new subscriber if I hadn't mentioned I will be trying this have a mini lathe and it's and same with the Big bend South bend thank you for sure keep up the amazing videos Sam

se pare ca principala cauza a uzurii rulmentilor de la arbori este carcasa cutiei care strange (preseaza) prea mult. am 95% aceeasi cutie pe Megane RS si am fix problemele astea :) se poate aleza din carcasa in lacasul rulmentilor insa determinarea cotelor este problema. (in Romania)

thank you for sharing mine truck make the same noise in 5 and 6 gears only

'Promo sm'

without hardering, that gear will not last

well done Stefan.

Did you install number 1 jaw to the number 1 slot? Did you try tightening from all three nuts, only one should be true. back in the old days(when I was still in Cluj) we used to use a die at the last set of teeth and grind until then, and at the end we ground off those last set of teeth. Also another thing that could be done, is to make an adjustable chuck, with set screws on the side of the chuck and increase the gap between the chuck and the spindle step. These are called Set-true chucks.

Chuck should be rotating as slow as possible while grinding

So this is how you stay in good shape 🤙

u need to use borax for better melt and remove the slag

nice job !

I have this mill was it easy to add the DRO?