Відео

With SolarEdge, if you have a bad connection on the roof, it is almost impossible to find it. Each optimizer has six MC-4 plugs and six sockets and they are wired in series like old-fashioned Christmas tree lights on the four string plugs/sockets per optimizer. If you have 13 PV panels and optimizers you have 6 x 13 x 2 = 156 MC-4 male and female connectors that can go bad. If the inverter does not connect to the optimizers due to one bad series connector it goes into "night mode" and production drops to zero. Try and find that poor connection in the wiring underneath the panels without lifting up all the panels, and even then, you might not be able to tell which of the 156 connectors has failed to carry current. Enphase doesn't have that problem; all a bad connection creates is the loss of one panel's contribution, since they are all in parallel.

Solar edge is good for no.one contains like anything made in Israel the souls of thousands of Palestinian children

This video has flaws, some of what you said is no longer true for some years now, pretty much all the solar panels made today have internal loss removal diodes that greatly reduce losses for shading or mismatching wattage of panels. The bad thing about microinverters is that you lose about 5 to 10% of the power your panels make because they lose energy in heat when going back and forth between DC to AC and back to DC for batteries and batteries DC going to AC which can be bad if you only have a small array. Both Enphase and SolarEdge both have positives and negatives. Pretty much all the new solar panels made in the last 4 or 5 years have these diodes that remove losses.

what do they cost, duuuuuuu

Solar edge is rubbish but you get the added bonus of the souls of thousands of Palestinian children,if anyone can live with that

SolarEdge is NOT “the best of both worlds”. Like a string inverter, the SolarEdge inverter is a single point of failure. One of our 2 SolarEdge inverters has gone down 3 times now in the past 7 months, and it took 3 months to get it replaced. You acknowledged that, but seemed to brush it off as an “oh, well”. That is completely unacceptable! If they never went down, that would be one thing, but that’s not the case. We will be dumping our SolarEdge devices for Enphase.

So if the display goes out the entire handlebar stem has to be replaced?

Theyre both great folks. Pick whichever fits your preferences.

You made a huge mistake by compared them. Both companies doing a very BS job.

If you a homeowner don’t buy SolarEdge I did 3 replacements for 1 home within a month because it was refurbished equipment

You are talking a lot of nonsense. There is only 1 important calculation and that price performance. Cells range from 19 to 22 percent efficiency. Most cells are so similar over 25 years that your variances are unimportant. The drop in energy at the inverter is far more important. Solar panels start at 0.08 $ per watt. The problem with the USA is the 25-35% tax added on when they arrive in the USA. 96% of all panels are made in China irrespective of name on them

I’ve had my 10.5 kw solar system with SolarEdge inverter system for three years. On the anniversary of the system the inverter died. It was down for a month with free replacement. Luckily it didn’t affect the yearly production, that bad. We have been ahead of this grid game with SCE, so far. We produce more KWH than we use, but they charge us .30/kwh used, and they give us .09/kwh that we send back to them. I’ve heard it’s going to get worse. That is why I am starting my investigation into battery storage for this SolarEdge system. Except for the house AC, we can disconnect Edison and live off grid. I just don’t know how much battery I need. Any formulas or charts I’m going to need to figure this out??

Another thing most people miss is that just because you are charging batteries from DC in the case of Solaredge, does not mean there is no energy conversion taking place. An optimizer is called a DC to DC converter for a reason. Another DC to DC conversion also happens when charging the battery from solar. Thus it is not accurate to say there are no loses in a DC coupled system. And after 9.5 years in the PV industry, with more than 2000 sites on our fleet and multiple NABCEP certifications, I'd always pick Enphase over Solaredge any day of the week and twice on Sundays.

Why did you leave Sunbright?

Ooof. So nice to have the impression that the video presenter on this complex and divisive topic lacks bias, a perceived relationship to a product, or unquestionable certainty. So thank you. I'm still in the shadows with installer suggestions on offer though. Bit your vid is helping in the right direction .

Realy bad video! Panels these days are pritty good... - a diode and solarpanel compare.... 😂 - if you do not have a lot of shade - just put them in a string... micros are just costly and do not add value all the time! The big fields don use these... they never break! Micros warrenty sucks...

Enjoyed your video - thank you. I am looking at a future home DIY 48V battery backup system, and have a partially shaded property that could greatly benefit from micro-inverters or optimizers. I've only heard rumours but, is there an off-grid micro-inverter or optimizer system available? Would very much appreciate your input. Thanks so much.

For Enphase you would just need to add another circuit. It's designed this way to increase safety and longevity. At this point these are about the same as far as comparisons. The other nuance is the amount of copper wire and gauge required for long DC runs.

The rectifier comment is partially true though it may be simpler to state that their Inverters are Bi-directional as the Microinverters in the batteries are bi-directional. Also there are 6 inverters per 5kwh battery so redundancy is x6 for the same amount of stored energy. If one X-BAT inverter fails the homeowner still has access to all the storage. In this case the Battery fills the low production gaps of the Solar if a cloud passes over. Enphase allows PCS controls so you can put 30-40Kw on a roof when the Main Panel or utility limits you to 7.68kw the way Enphase does it is far superior because if you connect a car to charge it the system will release all the power and yet limit what only goes to the grid.

lots of schrott

There is no way to compare a central inverter with micro inverters. This is the moment when people needs to understand that for a non significantly difference of money they are able to get a micro inverter system. I don’t wanna explain the reasons, there is too many information about this but definitely, it’s no brainer decision to move forward with a mirror inverters, also, if you move with SunPower, the company I work with, I will show you why it’s not just about inverters, but the choice of the panels, and also the important consideration in efficiency terms and quality of materials. As I said, anyways, I highly suggest to move with a micro inverter system instead.

Very good explanation, very simple for homeowners to understand.

I don't think your point on if one panel in a string is shaded, the rest are brought down is true, at least not anymore. Several hands-on videos out there that debunk this, at least with modern panels. Doesn't mean there aren't other issues but I see far too many pushing this point when it's not true.

Is everything still the same for 2023?

Great video - it made is much easier for me to interpret some of these spec sheets. Funny to see the Tesla panels underperforming compared to the competition.

In case you are wondering what that weird alien voice noise is at the end of the video, I used Premiere's new AI vocals enhancement tool and it hallucinated some alien noises into my audio!

Thanks for the review. I'm considering the Favorite XR Pro along with the Aventon Pace 500.3 and the Velotric T1. I'm an urban rider and I want a riding experience that is similar to a regular bike, but with a little boost.

I decided today I want get solar at my house. I was looking at various different videos on what to lookout for. Your videos are the most in-depth and simple to understand videos I seen so far. I watched all the videos and gained alot of knowledge. I'll be contacting you at some point soon as my sales representative. Thanks.

Thank you, you do a great job explaining the world of solar.

Nice vid but need to update for Enphase IQ8 please

About pricing now (speaking about the Inverters)... I'm doing a lot of DD on Freelancer Finance channel... From all my research Solaredge is maybe $500-$1k less... for a system that costs 30-60k... and will last 25 years... it's a no brainer to use Enphase and not worry about a central inverter failing even for a day (if not for months).

Good video and fortunately I have both an Enphase solar system of 10Kw and a SolarEdge one of 5Kw. I like them both, but I prefer the Enphase one where I get maximum wattage due to the IQ8-H microinverters.

SolarEdge "99% efficiency" claim is misleading. DC optimizers (upstream from the inverter) have ~2% loss each, which conveniently gets ignored in the marketing material.

great video, but why didn't you use the data sheet for IQ8 models?

enphase battery fucking expensive against SolarEdge Batterys what you can build up

hey sorrosh thanks for the explanation very helpful and in depth. how do you size the solar edge inverter size according to panel size (ie. 4kw 10 400w panels) thx

Thank you for the video