Відео

@@alfredoromualdo9715 yes it can be lowered to 160mm

@@JohnUyArts And is it the same process as in the video or do you have to buy a different air cartridge or do you just go through the stop inside the fork like in the video?

My question is why I want to buy a durolux 38 of 180 but in recommendations for the geometry of my bike that I have is a trek fuel ex 5 it says that I can only increase it to 160mm I would like to buy another bike later that can be put at 180 and thus be able to Modifying your route is the same process but the opposite of your video?

@@alfredoromualdo9715 it is actually ok to have 180 with your bike. Yes its the same process.

@@FerminCabatas lazada na sir bisan asa hardware nga naay Bosch

@@adamcollentrials just use any synthetic fork oil, just stay away from heavy weights it might be too slow in response. To know the level, set it at maximum extension, fill oil, compress and let it overflow, extend again, then close everything. The idea is fill it full enough and prevent it from exploding during compression.

@@MichaelPanilag-x8u wala bitaw ko idea sir hehe generic?

@@ciantiffstiff wala sa low end models sir hehehe

@JohnUyArts ah ok sir

@@eboysvlogrenz3683 hehe salamat sir, hinayhinay ra ni sir kay tigomtigom sad, plan ko modify headlight and tail light puhon.

@@jadelouiedico8455 Lapulapu sir

@@AlexSaints-t2k yes sir

@@JohnUyArts paano po master??

@@AlexSaints-t2k need spacers sir

@@joekool9601 ohhh i see, i think there is a spring that pushes them apart images.app.goo.gl/mwmJhStSfFuzbZgj6

@@JohnUyArts yes yo are right there’s a spring and a little rod that goes on top of spring , I lost the spring but now found it thank you

@@indeedinteresting2156 yes basta good pa air spring or coil spring

@@JohnUyArts Thanks sa reply sir. Sira rin kasi yung aking epicon fork cartridge, may tagas ng oil at wala ng pressure. Nag order ako ng cartridge pero di pa dumating. Bike na bike na ako HAHA.

@@indeedinteresting2156 disposable kasi yan, kaya bili bago cartridge

@@JohnUyArts Oo sir. Inassemble ko nalang ulit ang fork tsaka ginamit. Hinihintay ko pa yung bagong cartridge na dumating para ma install ko na.

Same lang sir

sorry I only have time lapse

Lazada or Shopee

Well this is just unboxing. To answer your question, i have used this many times now, for automobile its good enough (⭐⭐⭐🌑🌑). For household use, its a ⭐⭐🌑🌑🌑 Yes it can clean, but just enough power to suck dirt, its more like a 1/4 power of a corded vacuum

@@JohnUyArts That doesn't sound like much power.

Yes I did this at home, with just an ordinary soldering iron, its a crappy one actually.

around 5 to 10minutes

also depends on what grit is used 😀

Im sorry i havent found any time for that :( I am mostly doing things for a living, its difficult in our place

WNew or Bangood

Yes no problem at all, it also makes the fork stiffer and stronger even if the improvement is small

Yes it is used to drill ceramic and porcelain tiles but use at low rpm like 400rpm, best if used with water

yes you can have it fixed in your local electronics shop

random orbit sanders are design for finishing works. the 10,000 rpm is referring to the orbits (the tiny circular motion that causes the main sanding action) not the rotation of the pad (the slow rotation that is trying to remove the orbital marks during sanding). when there is no speed control, the sander is powerful enough. but with speed control, the lower speeds are almost powerless unless you use fine grits on those speeds. the reason is the universal motors dont have strong torque at low speeds due to the variable voltage regulator used as speed control, universal motors perform poorly on voltages below the initial design of the coils. have you tried cordless brushless motors? they perform really well even with low speeds because they are current controlled which increases power during loads at lower speeds.

Thank for explaining, currently I'm using corded sender, but me already placed order for GEX185Li, i preferred cordless sender all because of cordless sender are more convenient to work. Once received my GEX185Li I'll compare with my current corded sender.

Try lazada

It is brushless, the electronics takes up more space inside, vs the older model which only houses a dc motor

1619P11715