Відео

Saw another video where the guy used an extension cord to hook up to a separate circuit ground to make sure the power back to the breaker was isolated. Seemed like a good idea…

Confusing, low, high, low high, level 3, level 4 and so on. Which one will find the proper wire.

I bought this unit and found out its not as acurate as the et 310 to trace a breaker. Im very disappointed with this et450. I guess if you like to trace underground wires it might work. . Look how long it took this guy to trace something. It took me second to find a breaker with the et310 but this one took me almost 6 mins and some i dint even get to find!!

Do you have to bleed the system when you change it?

Observed people used this seems mediocre at best. Anyone agree?

I just got the smaller circuit breaker finder and it doesn’t work correctly. I don’t know what I’m doing wrong.

Gfci breaker?

I always scan on level 2 at the breaker/ wire and scan the whole panel over twice. my tracer will read 0 after i shut the breaker off until i take it away and try scanning again at the panel. I've come across what i assume are shared neutrals that cause false readings but the tracer has yet to lie when i take the moment to trace everything over.

Anytime it hits 99 it’s good to lower the number, because it means there’s interference or just too much signal. Also when scanning breakers, I find it helpful to keep the receiver closer to each switch rather than the hot.

Thank you so much im doing mines tomorrow well today lol

Thanks bud 😎

I have two 2000 Dodge Durango They Both over Heat and caused Blown Head Gaskits the 4.7 Motor are more than likely will have a blown Head Gaskit. I would completely flush out your cooling system And Never let your engine over Heat

You should try the veto pro pac bags

Man bad ass tool layout im in industrial as well love what i do man u should consider a pair of ratchet cable cutters those are some life savers, expensive as hell but they pay for themselves

no entendí nada 🤔

4:48 😂 great tools btw

What makes using a “brushed” drill more difficult?

Very nice video...Just wondering what brand of tool bag are you using?

The fish tape puller on any linesman pliers will bend up the fish tape no matter how careful you are. Better to pull with gloves on

whats the problem with the box cutters?

where's your pantaloons brah

Thanks for this video it was helpful

What state are you in? I've been doing electrical in the gas industry for years. Always like to hear and know what other do in the same field. Nice tool set up. I too like tools. Borderline addicted but can't ever have enuff.

We pretty much got the same setup. I can't say I use my swivel screwdriver more than once either. Lol