Відео

I used cross stitch to join the last two skins. I made it thinking that the seam would be small and it could create a gap in a single row of stitches. You can also do it as a straight stitch, you just need to be careful that the upper skin remains on the outside so that the rain does not get inside.

​@@goatroive seen on the pattern that the part where you glue in the zipper has tworoes of stitching holes at one of the small sides. What are these for? Because i dont see two rows of stitching in the video. :)

@@dukehorndrake5525 Hello, can you send photos via Etsy?

​@@goatroyes I can

The bag is not for sale. You can reach the pattern link to make this bag

Drawn on A4 paper size

Se puede descargar el PDF?

Você colocou o PDF pra vender mas, não está no site.

I'm a little short on video. Anyone with some experience can easily do it. Everyone who has ever bought it has created the bag. I give small tips in writing. I support them with mejas wherever they get stuck.

www.ebay.com/itm/224372027426

If you do not have this product, you do not have to buy it, you can do it with pliers. You may need to use tape so that the pliers won't make marks.

@@goatro wonderful, thank you so much!

Looks like 1.25 inches to me.

I'm selling the mold for you to make this model. You can reach it from the link in the announcement.

Room temperature water is sufficient. If you are going to paint, first create the mold with water. After drying, you can paint from the top. it would be easier to learn to gain skills in this job. It may prevent reshaping after the paint dries. This is a good way to avoid making mistakes.

@@goatro What about dying the leather? Before or after wet molding?

Reply on Etsy was : You can use leather with thickness between 1mm and 2mm. The thickness I use is 1.2-1.4 mm

Thanks for the recommendation, I'll try it.

There is a pocket on the back of the bag, I used this pocket to separate it from the bag. you can use lining or fabric

Hello, the leather I use is calfskin. The leather on the front surface is 1.7mm soft, the back surface is medium hard and 2mm thick. You can use it on different skins. Since it will be used as a bag, you can make thin skins loosen quickly.

@@goatro How much calfskin needed for this project?

If you watch the video you can create the average size in your mind. You can make an estimate in A4 size. I didn't make an exact measurement calculation.

@@goatro I was asking about the type of leather (veg tanhage, chrome) you used for the bag i this video. Any advice is appreciated.

I found the answer inside pattern pdf file: calfskin 1.7 mm soft. Thank you.