Відео

This works! I have a 2014 s60 and I figured it would be the same. At first it didn't work and was a bit demoralized but I tried it again the next day and it worked after the third time on the rear left door. The rear right was still working. I did this as well on the front passenger side. After two attempts it works. Now 3 of the 4 doors work. I will try the driver side another day. I used a 6 inch t25 bit from home depot and was plenty long enough. I also used the husky precision bit to scrape the connector but even the smallest flat head I felt like was bit big. I used the connector cleaner from Canadian Tire to clean the connectors.

THANK YOU!!! You are a genius. Just like you, it worked on the second attempt. Volvo would have charged me hundreds just to identify the problem and then more to fix it. Do you have a solution for parasitic battery drain on S60?

Hej! Jag har liknande problem. Har du löst problemet? 🙂

Bra lektion för hemmapulare. Intressant se hu rfackmän jobbar. Men kan man ha Wago till FK-kabel?

Men faan ok bra video men ingen bra förklaring vilka inställningar det ska vara har knappt ljummet golvvärme ingen värme övervåningen på radiatorerna skitkallt

Hej Har du stängt bloututh?

Hello, i have a problem like that in Volvo V40 T3. The driver door wont open from the outside. From inside it works fine. Thanks, Ruben

Tack Jacob, Mycket pedagogisk och användbar video. Tumme upp!

Just like on the video, didn't work on my first try but worked like charm on the 2nd try. Thank you.

Hej, jag kollade trycket igår och såg jag att den är under 1 bar (05). är det något fel elr bara för att det är sommar nu?

Thank you for sharing this video! I was able to fix all my volvo v40 cc doors. It was great to see you fail at the first time because it happened for me also with one door. I knew that it still might get fixed if I keep doing it because you were also. :)

Hvordan??🤩

Some extra information: (1) The actual length from the door panel to the T25 screw is about 86mm / 3.4in. You will actually need a shank that is slightly longer. (2) The 5 turns is good advice, but you will also feel a slight resistance in the turning when you get to the correct point for stopping. Do *NOT* force the screw once you feel this resistance!

Work of genius - i bet even the local Volvo dealership don't have your skill and knowledge

My door handle is now broken thanks

Thank you so much, I am just having the same problem! Very useful video!!!

How do you link Plejd to Hue,are you using Homebridge on computer with it?

Toppen! Stort tack

Does it work the same in xc70 2016r? I have keyless go but with the rubber buton on handle ?

USER ERROR!!!! Herregud, ladda inte in profiler!

Jag har Nibe F730 men har inte fliken (Service) hur tar jag fram den?

Thank you very much, video is still helping :) Fixed my front passenger keyless on V40 2013 :) Working smooth after first try !

I think this part of zibomod should be in focus for coming releases. The autopilot / autothrust modes work ”okay” but either the FM or some calculations or most likely both are off.

You are just seeing that the flight model is too draggy in lower levels. It causes the need for thrust bursts during descent. And especially strong slowing down if you take a direct. The flightmodel drag, vnav path calculation and resulting path is not correct.

Thanks dude, this is really useful information. I was thinking about getting two of these for a twin stick for Elite Dangerous. This explains the £99 price point.

Kan du göra en video om hur displayer i rummen funkar? Mvh

This is normal with lower end joysticks, they aren’t that good. I’ve ran heavy equipment, it takes awhile to figure out the nuances of the hydraulic controls and dead zones. Maybe you could pretend that this joystick is acting like a real joystick 😂

Om värdet faller med t ex 20? Vad har man för fel då?

Very nice demo, well done

Hi man, thank you for a great tutorial video. I have Volvo v40 2013 and i assume that they have a same problem and the same fix. I going to try that tip, hope that works for me also.😊

Thank you, mate. My V60 has the same problem. Hope I will solve it ) Regards.

Lite nyfiken på om du fick klarhet i vilken inställning det ska vara i meny 5.1.14 vid golvvärme bottenplan och radiatorer övervåning - är själv konfunderad över detta och kan inte hitta något bra svar?

Jes still an issu!

Tja! Inte ens Volvo själva kan svara på denna fråga, så hör med någon som äger en MY24 XC40 Recharge. 1. Fick du med en Shucko/vägguttag:s laddare till bilen utöver typ2-typ2 sladden? Samt, finns det ett 12V uttag i skuffen/bakluckan? Tack!

Many thanks very good advice! Three door locks later every keyless working well now :) excellent know how video😀👋

Ääääääääää 😂😂

Is this still an issue you have? I am considering Brunner MKII for Zibomod. But if the SW support is totally random, I guess it's too much money to experiment with?

Du är bäst . Du har sparat mig 12 läh!

This just started with my driver side on my 2013 t5 s60, Ill give this a go. 93k views, hmmm I wonder if there should be a recall?

Any tips on how to get the left back door handle to pop back in place at the end. Was able to do it on right hand side. Left hand side, I tighten the screw and handle doesn’t pop back to flush (normal) position.

"Promosm"

Hej. Does it work if I start the lights with a normal switch, then turn the lights of by the dimmer switch when I get to sleep. And when I go at work and come back home to turn the lights on by the normal switch again, even if the dimmer switch it's off?

V60 2011 it did not worked for me. In my case, keyless is not working for front doors only. Rears works completely fine. Surprisingly at first try, rear also stopped working as in clip. I tried switching door handles around - still no luck. Help would be appreciated.

Dielectric grease might work. Electronics on volvo cars are problematic because of where the wire looms and connectors are manufactured .......Italy.

Good to see that the rudder and tiller has finally been fixed. I thought that the problem was nothing to do with ProSim and was totally an MSFS problem according to Lapi. Curious because he is NEVER wrong.

I have a 2016 V60 D6, but the keyless doesn't work on any of the doors. Also i have to put the key in the ignition to start, it wont detect the key at all. My first thought was the key battery, but i replaced the batteries on both keys and they still don't work. Will this fix it?

How long does the torx t25 screwdriver have to be?

Visar verkligen hur värdelösa Torix är på alla sätt. Bra video för upplysning.

Thanks, all my S60 handles are working again. I also had to do the front door (watch out for the driver's door - you need to push the little beak underneath, which is there because of the door lock)