Відео

Any way you found to access the kinked tubes at the exit?

Hi，why did u torque with 50nm instead of 70nm as ISTA says ?,is there any reason for ?thanks.

Hello man, I have a problem with my BMW F10 N47, 184hp, it maintains operating temperature, but when it goes over 2500rpm the temperature starts to drop sharply from 88 degrees to 63 (water), and the oil temperature drops, but a little slower and I can't do the DPF regeneration, I changed the thermostat housing and the water pump thermostat, the entire set of gaskets that you changed, but i dont change transmission thermostat, do you think it's because of it? Thank you

Kudos keep it up

Very helpful video for those who intend to diy

My 320d had exact such leak it's not a simple job to replace that pipe i diy and took the chance to also replace top cover gasket since it had leaks ,be carefully on a single pin wire which goes on top of the alternator i broke mine i had to do some modifications

I have the same Screen kit. You did the top portion, but what about the instructions for the bottom ????

First video I've seen with the tightening sequence included - thank you!

Hello, what Diagnostic System have you? I need one for my e92 Thanks!

Seems like a 3 hour job but will take 9 on your driveway

This is a 2014 x3 by the way

It worth watching

Merci pour votre vidéo ainsi que les références des pièces. Entre la coupelle d'amortisseur et l'amortisseur il y a une butée en plastique, est elle comprise dans le carton des coupelles d'amortisseur? Merci par avance de votre réponse.

Salutare, poți să ne zici te rog la câți newtoni se strâng cele 4 șuruburi de la capac? Mulțumesc

Ótimo procedimento para reparo da Cortina do Teto Solar da X1, parabéns pelas informações (melhor que encontrei na Internet).

Great video

Thank you a lot my friend! It works perfectly! 😘 from France

Et bien moi j'ai changer cette pièces et le thermostat principal malgres tout ma 530d f10 ne chauffe pas assez

Why when you remove the handle not notice its unplugged already?

Hello, I have almost the same problem, it's an e39 525d, I changed the relay, I start the car and it turns off after 3 seconds, I changed one of the pumps under the sic, you know again what would be the problem

Where is the auxiliary battery

I removed 2 screws holding starter from upstairs You just need flat E12. It goes easy.

why do you need the special tool holder?, can you just impact the screws without the tool?

Can’t get window to go all the way down to reset . Any ideas ??

I have completely opposite problem, keyless works, and buttons on key not working

Sehr gut Erklärung Respekt

I couldnt understand the values at the end, can you explain?

Hello, Great video, I did the front of the roof successfully. Do you have any additional information for the left rear? because I don't see that in the video. Thanks in advance for your help. This really saves a lot of money by being able to do it yourself with the help of your information. (I live in the Netherlands)

Hola cuánto te costó el filtro y donde

pe spate are si pe stanga si pe dreapta ?

Great video 👍🏽

Door latch ? You mean the door lock actuator right ?

Hey bro！I drive F31 320D LCI，but can also use the same Parts right？

Thank you, most helpful!

Good video. Thank you. Just wondering why the bendix contacts weren't replaced while the starter was out? Cheap and easy job after all the efforts to get the starter out.

Great video. I had the same issue, my question is the belt that needs to be replace. How I can find one? Please your help. Thanks

Come risolvere il problema?

And Subscribe and Thumb up

It's bloody awesome instruction video I ever seen last decade. Respect to you

If you kmow it is getting moisture in to the module, why wouldnt you put some dilectric grease inside the connector to deter future moisture?

Multumesc pentru acest video. Intamplator, tot pe partea dreapta aveam probleme. Nu ma pricep la masini, dar miu-a luat 40 de minute desfacut, scos dopul ala plin de noroi (nu l-am montat la loc, presupun ca e pentru a nu permite viespilor sa-si faca cuib). Am fost la spalatorie si nu a intrat nicio picatura de apa, desi inainte curgea din plafon.

I looked at several videos and this is the only one that shows the correct way to remove the plate. Thanks for this

Hi I go to dealership last week they replace free of charge egr cooler but I’m not sure if the also replace the egr valve does is come with it ?

Thanks for your help. Very good clip.

Is there any risk of the engine timing being out by removing the pulley?

My pump leaks. Can I just replace the gasket? And how much coolant for 530d?

Same problem with 2019 520i m sport. Would this be the same removal process

chyba to hdi nie dci!

Thanks mate, the video was very helpful. I however ordered the wrong part from BMW dealer but it fitted fine and has same specs, cleared the codes, hoping won't see the error again.

You should have menched that the injectors are coded and have to go back in the same cylinder they came out of.