Відео

sick explanation

Do you have any trick for V0k method in Petrel? Thanks

Why you draw phi from the center? Phi degree should count from the perimeter.

That complement doesn’t work

How we stabilizing this For increasing the slope of cut or decreasing The friction is it as The bedding plane as it is

10 20 30 50 60...where is 40?

Thank you very much 🎉

help

An open pit rock slope at your mine is intersected by two fault planes and a set of major joints. The dips, dip directions and friction angles of the faults and joint planes are given in the table below: Plane Dip Dip direction Friction angle Fault 1 60° 114° 23° Fault 2 80° 250° 20° Joint set 1 40° 120° 25° The dip and dip direction of the slope are 40° and 164° respectively. Use the stereonet provided to determine whether there is potential instability in the slope. Then using the wedge stability charts provided, determine the factor of safety of the slope. Comment on the confidence you have in the factor of safety determined considering the advantages and disadvantages of the methodology used.

thnkz 🌻

Hi Sir Kindly refer any software to find out principle stresses with the help of dip and dip direction

3:10 4:20 7:15 9:35 11:05

Thank you, Mortaza

Thank you Mortaza

❤سپاس

بسیار سپاسگزارم عالی بود

Very good

thank you so much this has been very helpful for my undergraduate degree!

very informative and well clearly explained. Thank you Mortaza. Greetings from India.

Hi! Nice tutrial, but i use mac, how can i add the symbols? I cant find the file

Thanks a lot

Thank you!

what is this method called? Equatorial equal method? or pole method? Sir you put strike on 50 instead of 60?

Thank you so much - south korea

Thanks sir I am form india ❤️

Thanks .

Can we know the dipping direction of the last question (Oblique Reverse fault)? Or it cannot be determined with the information provided in this question? Thanks!

awesome video. Thanks Mortaza

You could fold the paper along the lines of the angles, rather than cutting.

great thanks for your very informative tutorial video.

thank you so much!!

How do we calculate the middle point of the stresses sigma A nd sigma C?

Tata??

Thank you a lot

Amazing explanation

Really thanks.

Very helpful for me thank you

Could you pls say why have you put the checkshot data under the well tab. Is this VSP data that has been taken from one drilled well or what? As i know the chekshots should be loaded as seismic lines. Thank you for answering

Thank you

Thank you four your sharing

what a hero

Thank you

Thanks

id love a similar video for toppling and another for wedge failures.

is this only for a plane failure?

From Morocco, thank u for Coulomb faille and Mohr cercle. Please can my students have more applications on this in each 3 situations: Normal faults, strike slip faults and reverse faults. Thank you.

Very informative, well done! I was wondering if i have a oriented core and measured Alpha and beta of a bed, is it possible to determine the strike and dip using stereonet? Thank you.

Hello brother, can i ask u question. If we have many checkshot how we calculate the depth. Because many well. Thank you very much. Nice video

A difficult subject explained in an easy way. Even a person newly introduced will understand. Well done

you just gained a new subscriber