Відео

@@bamabassgrabber it should fix it. That's why I tried this fix. Mine would shutter on take off and the shutter would stop at or around 10mph... This kit comes with 3 stacks of spacers for each side . I wound up having to use all 3 to correct my shutter... Hopefully this helps you out .

@@Dannyglaze thank you so much. It just started a week or so ago and I've been researching all day. Would it be bad to drive awhile with it like that till I can replace it or no?

@@bamabassgrabber No... I drove on mine for over a year until I was able to figure out that it needed the drop bearing kit after the lift. It's pretty common with the tundras, tacomas and 4Runners and even the sequoias.

I don't have a lift on my truck though...does that make any difference

@@bamabassgrabber you might want to check your drive shaft. Make sure your carrier bearing isn't loose. Just get under there and wiggle it. If there's a lot of play you might have a different issue. But normally what I'm describing or what you've been reading occurs after a lift has been done to one of these trucks. Also too before you possibly go into a panic. Don't yet. Make sure you grease your universals. Prior to my lift. I had a vibration similar to the launch shutter vibration and it turned out when I bought the truck. The universal joints were not being lubricated and hadn't been done in a while. And that corrected that issue. Hopefully this information helps you out

@@LassSmith88 appreciate you checking out my videos and shorts. The Tundra will be changing a little bit soon. ❤️

@@pauliedphan9651 That was a flood in Harrisburg.

It's been decades since we partied at the infield of a NASCAR race 🤣🇺🇸 I wish I could get the old man to take better care of himself... He loves the beach, but he's happy being old rough and toothless these days 🤣🤣🤣🤣..

It's held up just fine . No complaints on the product... Just very disappointed and dissatisfied with the owner . I rate the roof rack a 10 but beware if you need to order spare parts or need assistance you will be on your own . I was chatting with Spyder for like 6 months, trying to purchase another rail and some hardware.. He strung me along and made multiple empty promises on sending these parts. I finally gave up . So rack is a 10 and Spyder currently holds a 1 in the ratings.

I have many updates and mods . I'm not getting the best mpg and this is my daily driver. I run with this tent on a low profile hooke road bed rack, so with nothing else on top of the tents luggage rails it wasn't killing my mpg.. but keep in mind this thing weighs close to 200 LBS.. hopefully this helps you.

I had a bad vibration after my 6 inch lift. Most Toyotas after a lift will most likely require this update. He is a link to my other video which shows the cv Axel wobble. ua-cam.com/video/5GfP5kTD0ro/v-deo.htmlsi=bBxVYoB3XLBia5sU

My taco has some steering wheel vibration on 30 to 40 miles an hour,my driver side cv axle have the same play at yours

@@javiervallecillo1791 you might want to look up east coast gear supply . They have the bushing that replaces the needle bearing, trust me that vibration will drive you insane. You might want to check out the Tacoma forums. Lots of taco owners have had to do this upgrade. It's not that hard to do. But well worth doing to correct the vibration.

@@Dannyglaze yea I'll check it out, thank you for your help,have a great day body

Hello.. I can confirm that the 2019 Santa Fe with the 2.4 engine has a timing chain . 2 things I did to confirm this. 1st I went to the Hyundai web site for OEM parts . I put in my VIN number to confirm correct replacement parts. My VIN gave me the only option for a replacement timing chain. Also the 2nd is the timing cover . If the timing cover is plastic you'd have a timing belt, if your cover is metal or aluminum, you'd have a timing chain . Hopefully this helps you.

@@Dannyglaze well i must have a chain then, thanks!

I believe some parts were mirrored. I originally had the help of a"camera person"

Unfortunately..no I've not worked on one . I haven't looked on UA-cam but I had a diesel heater that requires you to open up the bleed screw when changing the filter.. hopefully this gets you in the right direction.

It's 10 inches... That's on my 2010 Toyota Tundra.. that will vary in height on different trucks that the deck system is installed on

Hello.. I've had my spider rack for almost 3 years great product.. but a warning, I attempted for almost a year to get a part, and the guy that owns the company "spider" gave me a run around and multiple broken promises on shipping the parts I needed. I finally gave up on begging him for help. Hopefully this helps you.

@@Dannyglaze yeah I saw your previous video regarding that. I also see they advertise their hardware for sale now on their site. Appreciate the feedback.

Hello.. the bed rack can be purchased from a few different websites. It is the 12.2 inch high overland bed rack fits Toyota Tundra hooked road. The RTT by Naturnest is on Amazon. Hope this helps

Hello.. weight wise I don't think it would be a problem. I'm not a kayaker but I've seen others with cab roof racks with a kayak on top. Hopefully this helps you

Hello.. my 2010 tundra bed size is the 6.5

Hello. No it is not necessary. I've learned with any vehicle that is over 10 years old to be prepared.

Hello. The rails are 5 ft long and roughly 2 ft 3 inch apart from each other. Hopefully this helps

Thanks buddy. someone else said theirs were 70" long. my crossbars are 68" apart.looks like the tent will not fit if they are only 60" long. looks like i'm looking for another tent.@@Dannyglaze

Just a thought.. you could get 2 rails (stock aluminum or light gauge steel) bolt those down to your crossbars, then mount the tent to the 2 rails. Hopefully you can visualize how I'm explaining that to you. But just a thought.

I'll probably do something like that. thanks again for you help. I appreciate it.@@Dannyglaze

Hello. About 2 months ago I installed a cargo carrier on top of the tent. I have almost 100 Lbs on it. My Truck is a daily driver and the tent opens with no problems. Hopefully this information helps you.

Hello, It's 6.5 feet

Honestly, I was almost set on purchasing the hard-shell RTT that Rough Country makes. What really sold me on the Naturnest was the fact that I can carry additional gear on top of the luggage rack as where the rough country would have lost space. The other was a $500 price difference.

I just illustrated how I ran the switch and mounted the unit .It plugs into power and ground. And you run the other wire to a fuse in your box that turns on with the ignition.

Hello. That is made by HookeRoad

@@Dannyglaze thanks !

Actually, no whistling from the bumper. I did another video on it.. check it out if you get a chance. Black Friday deals are coming. Hopefully you get one and save some money on it .

If I remember correctly , it was 400 Lbs static and 200 Lbs dynamic... Broken down the rack will hold up to 400 Lbs but once your truck is moving or driving off-road it can really only handle 200 Lbs.id refer you to the guy that makes the spider roof rack but I gave up on reaching out to him for any questions.. he makes a great product, if you need parts and things you'll find out fast that you're on your own. Hope this helps.

Thank you 🙏.. This RTT is awesome.. we've still not used it yet in the rain. But I have no worries that it will let us down .

I Have not used this yet in the rain. So I haven't truly tested the waterproof aspect of this tent yet.