Відео

Thank you! Mine just died and used your video to figure out where to open it up, right side it is!

What kind of screwdriver is needed to remove the backplate?

Reason if cant turn on machine?

Can a stove be attached to the output of LPG converter and get a flame when the ignition is turned on ?

Hi, I have an DELONGHI ECAM, I fixed the clogged tubes but when i take the infuser out and clean and placed it back, the machine keep displaying "INSERT THE INFUSER ASSEMBLY" and no matter what i do, machine keep displaying the same message. Any idea why??

Thanks for the video

I a sharing audi restoration videos. My car needs LPG system renewment. Thanks for helpful videos. Thanks too much.

I'm interested in importing the parts for conversion of my 2003 Toyota corolla. Can you help with the parts required? Thanks

That may cause cracks on the cylinders direct injection method

Does these systems have a flame arrester?

Zaczepy od wyświetlacza pięknie uszkodzone. W życiu dołem wyświetlacz się nie będzie trzymał. Wyświetlacz odchyla się i przesuwa do góry. Ludzie nie uczcie się od tego Pana !

Hi! I have same machine but the issue might be different, it doesn’t respond to commands, if is plugged in, is playing alone: switching on and off, water comes out and in the end I cannot make any coffee as buttons are not responding to orders. What that might be? Thank you!

Better explanation. 👍🏼

here is a dumb question -can one use natural gas used for cooking etc [ methanes?] instead of lpg,thinking of adapting the filling nozzle to be able to fill from tank from hardware shop....

If your still around got a old ford on fuels and a gastec LPG had to replace the fuel tank due to contamination the sender unit was stuck half way and the positive was on the resistance line always half way since I disconnected and accident had on two occasions the system on in on position the gas was leaking from the pump since the fuel pump was not hooked in once replaced the gas relay is working after saturated and turned to off still runs fuels or gas and you can switch via the switch added gas line set??. enquiry on why!.

Hello. I cannot remove the transmission before the infuser is stuck and I cannot manually remove it. Is there a way to still remove transmission?

Sounds like a sensor (more like a switch pressed by infuser carriage moving too far along its axis of travel) is not triggering. I simulated this behavior while troubleshooting my ECAM which had trouble with sensor counting rotations and refusing to work after self diagnosis cycle.

I am an expert in LPG conversion,any job?

Delonghi est vraiment trop fragile , trop d'entretien!

good share

Thank you for the video! I have problem with milk not working/frothing or sucking into the plastic straw. The water seems to be working fine from the water sprout, and do get hot. I got no continuity though, on one of the two white temperatures sensors 318C, that you showed in the video 5:44 timeline. Anyway I’ve ordered a new one of those. Sadly, could not find the exact one to match my model number. It looks the same, so I hope it works. Question: I can not find the exact solenoid valve that match with the one I have. The numbers varies between 5301VN10P46AIX and mine 5301VN27P50APX. Are they working differently or is it fine buying even when different number? Both for Delonghi of course. I wonder if it’s possible to order a similar one but not the exact correct model number. Do you know if it will work with a different one or you know where I can find the exact one? Gear I have: Machine - ECAM23.460.B Solenoid Valve (top one, no sound/hummeling) - 5301VN27P50APX Thermostat - 467E // Tf 318C // 155431078N Thank you a lot.

Fuel and lpg which one has more cunsaption

In my machine the piston of the infuser doesn't reach the upper position but stop at 3-4 millimiters from the top: the result is that a part of the coffee ground remain on the filter. Who know which is the problem?

HI, I AM ABOUT TO BUY AN LPG/G3 PEUGEOT 307, CAN I REMOVE THE LPG SYSTEM FROM THE ENGINE COMPONENT?

I can't understand what be wrong?

I got a cramp in my head while I was looking at this mechanism. You're a great engineer 👍

what can happen if you dont do an inspection of the system after 2 years?

Hello friend i get some issues in dodge charger especially in the gearbox there is stranger sound and vibration in the shifting of gearbox box what is reason please

Hii kan je ook LPG toerental verhogen zondag computer aan te sluiten? Door middel van schroedje te draaien? Inject motor bmw 6 cil

Dear sir,we are the manufacturer of automotive LPG/CNG conversion,if you have interest,pls cpntacte me whatsapp :+8615728041195

Hallo, Was ist den bei Delonghi Kaffemaschine obk? Danke für den Antwort.

Hi. I have used this LPG for 1 year. I found something unexpected that using LPG has more fuel consumption compare to gasoline. At the MID if using LPG 10/100 km liter/km. But if I use gasoline is 6/100 km liter/km. Is it normal? Due to Sales engineer this normal.

Few months now since you post this video? Did the machine show this error again?

contact No .09742803638 BATIA retrfit

We are retrofit of LPG kits in Belgaum Karnataka interested in getting dealership for stag brand LPG CNG kits for BELGAUM

Good job Thank you

Does Liquid LPG direct injection remove the need for gasoline?

Ik heb een bmw 535i op Lpg, alleen heb het raare probleem dat wanneer ik mijn kachel op minder als 32 graden zet de auto niet lang op lpg rijd ( hoog uit 10min ) daarna slaat die over op benzine, zolang ik em op 32 grade heb is er niks aan de hand, toevallig een iedee waar dit aan kan liggen

Ik heb een lpg in mijn 307 ingebouwd sinds gisteren gaat het tanken extreem langzaam. Enig idee waaraan het kan liggen?

hi, thanks for the explanation.....can the third gen system (indirect liquid injection) us standard type petrol injectors ? fitted into each mainfold inlet runner. cheers Brett

be kind, what drill diameter in mm did you use?

Mooie uitleg! Kan je ook een filmpje maken over wat er moet worden aangepast tijdens de inbouw? Wat moet er bijvoorbeeld worden aangepast aan in Ecu ? Moet de brandstof pomp worden uitgeschakeld? Wat voor een aanpassingen zijn er nog meer nodig bij een moderne auto ? Alvast bedankt!

Hello, you reckon this system is enough for 92kw naturally aspirated engine?