Відео

Que son los efectos que produce, cuando se tiene este problema, mi xts no tiene mucha fuerza. Codigo P0014

2010

A6 c6?

Done new motor or top end

Daaaaamn!! 😂😂😂

E ok!😂

I know what’s wrong with it ain’t got no gas’s in it

Missing a shim or two😮

Those never come off that easy 😅😅

Seized shaft for the water pump drive? Yeah. What a stupid design. Done a few of those myself and cursed them each time.

Engine tappet cover

Why is your Audi queefing?

Honda civic sport?

2&4 need to be replaced

Hey just go ahead and plug her back in and keep sending her. You don't need to worry she will be fine. Just change the oil all will be good

So the 2nd and the 4th are misfiring

that jig is whipping on that hood stretching the metal un necessarily

Damn that engine is beast 😮‍💨

what a sad joke

BULL for a HEADLIGHTS 🤔🤔🤔🤔

Nice❤🎉❤❤❤❤

Balla como cuesta pero cuando afloat sedescsnsa me paso con una pantalla los 4 tornillos de atras

Nice video ❤❤❤❤🎉🎉🎉

Dew j'ai good muy 😊

Subaru's aren't this hard to work on guys....

Very yes

I don’t think you put enough rtv

Ingenuous

Toyota , probably a Camry ... I forget but im pretty sure they non adjustable one is a pain in the a## to replace. Might be why they only did one lol. Best part is if it was aligned it will need another now.

Thanks for sharing this, good sir! 🍺

turning a 4 door into a 2 door? oh wait I see, replacing the rusty smashed in section

Its almost like theres so much tension still the bolt dont want to come out without missing some threads..

What’s the point of this video lol

این احمق هیچ آشنایی با ترکمتر نداره ؟

Works are very bad

Руки из 4опы !

Same s#% happened to me in a 78 t- bird when i was 17. Brake rotors disintegrated when i tried to stop behind a decelerating school bus that was about to let kids off to cross the street. I yanked the wheel to go full on Dukes of Hazard into the ditch next to me. Bout a 6 foot drop.

Customer swears there was no noise til TODAY. Came right over. Imagine the oil 😂.

Should be a brass hammer not steel if you’re gonna be doing it that way.

Back in the day you had to use shims to make the starter engage correctly to the flywheel

Might want to do a deflection test with a dial indicator that bearing might still be in specification 😅

Machallaha

Woah what happened to it?

Now let's see you hem the door without distorting it!

QUÉ CHAPUZA 😢

Some things never change no matter where in the world you are

Snowy to say the least