Відео

I got that one straight of Refina mate

Hardball would be high about 400 so start at about 500 and come down

@@mikeatthis8828 cheers bud

Depends on the wall and the weather really mate 👍🏻

Just the Congo cleaner mate

And silicone spray when its dry

It’s good on commercial works but not so good on domestic stuff .

Hi There it is a 2 coat system wet on wet. so work a few metres at the same time. start a the bottom and work up. spray say about 3m2 and go straight back over it. a garden pump sprayer works well . 1 litre will do about 5m2

He probably has been a few times lol

Thanks for sharing that

Depending on the pattern your looking for. That was a 2mm bigger cap with the air about 5 mm back David

Hi Kai . Pretty much mate and a quick hand sponge after that.

Here you go mate www.refina.co.uk/surface-preparation/power-float-sponges/epg400-16-power-sponge-float.html

Machine plastering has been around since the mid sixties. The uk is a bit slow on the uptake but I can clean it all down and loaded in the back of the van in less than 30 minutes 🤷‍♂️

I use this stuff mate Blitz 1 Litre Concrete Cement Mortar Remover Cleaner Dissolver www.amazon.co.uk/dp/B08BLG1CLM/ref=cm_sw_r_cp_api_fabc_F4jYFbN70H0V1 but it looks like it’s sold out CES hire do a version of it 👍🏻

@@mikeatthis8828 thanks m8 will track some down somewhere 👌🏻

speed 5 mate and half the water you would have mono 👍🏻

Hello mike Do you prime old brickwork prior to rendaid I’ve never used it got a full rendaid and mesh Weber mono job coming up on old brickwork I’ve only ever done mono on concrete?

If it’s only surface damage Silp in the same colour might hide it. Or cut out and re do it. Look for the Weber crack repair and you can do similar to that.tape up the edges though.

@@mikeatthis8828 thanks for speedy reply mate much appreciated, customers panicking like mad. I used ecorend gave one of their reps a ring and he's said to use their specialist paint over it so reckon gonna give it a go

You use a pointing trowel or back of a trowel to get it back close but leave the tape on until it is just damp. Then you can take the tapes off and scratch it back to a level plane and pick some more texture around the edges with a small tool. The idea is not to get any wet material on the old render and not to scratch the old render with anything metal

@@mikeatthis8828 great thanks for the reply

Mark Breen sorry mark just seen the comment I had it put on by Stuart

Rob Hall 50mm at one time you can prime and go again after about 4 hours It can go over insulation at 25mm

Jack W yes jack exactly the same method but in one day

MrTottihunter though I’d do a video for you 👍💪

MrTottihunter cheers mare.

macplastering do tell 👍

Mike Atthis Hi mate yea got it uploaded the petrol mixer from refina

macplastering nice 👍🏻

I can’t find it lol

oh here is the link it was a few vids ago ua-cam.com/video/bur3K-5vhWo/v-deo.html have it in use soon :)

MrTottihunter ok will do next time 👍