Відео

had this exact problem!!!! my fix was for the 5.7l v8 was that i have an exhaust leek at the head an manifold. and on the back of the block driver side a part of the wire harness is clipped next to the head, being it was so close to the exhaust leek it melted the wire coating causing a short.. i also had a code that said( battery would be dead after 50 starts), when i fixed the short, that went away as well// (PS)its worth a check. early to mid gen 5.7 are well known for exhaust leaks on the rear of the manifold due to heat cycles and can happen as low as 40k miles

Thank you. How much is this part and labor to ask the mechanic? I own a 2017 Ford Escape titanium. Thanks for video .

couldn't find the part to buy or a part number, HOWEVER, start by taking the top shiny plastic piece off the gear shifter, then those two screws, see if there is some broken plastic in there. That was what it was for mine, I started by ripping everything out like he shows, but that was unnecessary as it all (including the microswitch) was fine. It may save you a lot of time to just pry off that shiny plastic piece on the gear shifter and start there, either way thanks for making this vid!

Thanks for posting this worked for me! I just have a question how to put back those damm screws on those plactic base that are falling off?

Thank you, I follow your directions on my 2012 sonata and it worked. Thanks very appreciative

My 2012 kia sorento with over 200k miles was having an issue where after long driving and at freeway speed it would have a momentary lose of engine power. Like a fraction of a second the engine would not be combusting or something. I looked it up and many forums said it was the crank shaft sensor. I ordered it and asked a local mechanic to install it. They installed it for $99. It worked. It completely eliminated the issue.

Dealers don't like to do this work because they still have to take the engine apart to confirm damage, then it takes up space in their shop while they wait for Kia or whomever to approve repair. Then wait for parts. The warranty repair reimbursement is basically peanuts. It's less of a headache for them to kick the customer down the street and lie to them.

great video and work, maybe a suggestion to try to block out the personal information of your customer, there is a bit shown on the dealer papers.

Fred Beans Hyundai in Flemington NJ told my wife her santa fe had cracked oil pan and would cost $700 to fix. I immediately went and picked up vehicle and can not find a crack despite using magnifying glass.

Knob cap defect

I bet those two pieces were from underneath the knob cap.

I had a kia with problems like no power on the highway and all wheel drive was not working but the dealer said there is nothing wrong with it, I also had a ford and the computer would lock me out or not let the truck start or not turn the truck of or id have no headlights or heat and some time the 4x4 would turn on by it self and trans would drop to 2nd gear on the highway but every time I went in they said there are no code's so we can't fix it '' if '' it's happening, They did replace the computers and the wire harness and the alt twice and battery 4 times but nothing stuck, Last time I went in and was told there is nothing wrong I tried to open the door while talking to the guy who did the work and my door would not unlock or stay unlocked when I used the key and when I started the truck I had no radio and no fan and he looked at the dash and said No lights showing no problem code so I can't fix it, I had 33,000 miles on that truck and had to trade it at another dealer because it was not safe to drive, That truck was a problem from the day I bought it and I mean the day 1 because I left the dealer and went for coffee and my window would not go down and when I went right back to the dealer they said '' No code '' maybe you pushed the button wrong.

Damn..Im sorry this happen to her too. I hope they will fix it for her without too much trouble. I think the original engine was swapped out around 110-115k....If I remember correctly the new (used) engine was supposed to be around 60k but when we got it the mileage written on the engine was from the junk yard was quite a bit higher than that. According to the odometer , seems like she got around 50k use out of that junkyard engine which sucks , but is more than I thought it would get being a higher mileage replacement then we would have liked to get our hands on at the time. Probably would have died in half that time with my lead foot driving it😬

Wow.... it work, thank you

Great video!

How can we reach you for a heater core replacement on a 2006 Dodge Ram 1500 ?

THANK. YOU. After local mechanics said the solution was to have a new gas tank installed for around $1000, I watched your video and solved the problem for no cost!! (Well, I did go to Ace Hardware and bought a foot of clear tubing to blow through that inlet, and it cost me $1.25.)

Well hate to tell ya but half the junk parts out there are made by Dorman and stuck in a box with a different name. Even the dealers will have Dorman make stuff for them.

hi i have a nissan qashqai j10, also after installing the airbag spring, now i have esp light on and the car does not exceed 3000 rpm, i have aligned the steering badly. i tried several times to align the steering correctly with the marks on the column but nothing. i also did the sas steering alignment procedure. but the error does not go away it comes back immediately after a few meters. C1130 my error obd

Wonderful. Crack!❤

Fastest youtube fix EVER! Just happened, ran in, got on you tube, watched this, went out and 2 minutes later. DONE! Thank you for the fix!

Thank you!! You saved me from spending money lol :))

Thank you sir! This helped out alot!🎉

Wow great fix. Do wonder what that piece is

you just saved me a trip to the dealership or mechanic ! thank you ‼️

Thats cool u use atf my first job pumping gas we would use it for trans and power steering never had a complaint or anyone questing it.

How do I get the wiring diagram ?

Negligence does not make a great example. All plugs should be checked as well as compression all the way around. At over 200,000 thousand miles, change all the plugs and coils. WTF

I don't understand one cylinder says 200 the other says 175 is that good or not

Hi so my Nissan Rogue 2013 traction light and ABS came on but nothing else I tried resetting the dashboard lights and they still stayed on. any idea what it could be?

This worked perfect. Thank you so much

Thank you Cory !! I wish i would’ve found this video sooner 🙌🏼🙌🏼

That is super crazy it fixed my issue instantly I was like why am I messing with the shifter when it's the ignition but as soon as I took the Handel off and put it back on it didn't have anything rattling around inside of it like you said but I just took it off and put it back on and it released my key.

Awesome problem solver, I saved $380 almost

Thank you so much great explanation on how to check valve. Went to the wreckers and did your test....saved lots of $$$

Thank you.. big help😊

Thanks for this, exactly what happened to me. Plastic was from the cover with mine.

I use ATF because it's a detergent keeps the pump and seals clean internally

Gas and powered laundry detergent mixed cleans oil off concrete like a pro

Thanks for the video. It worked perfectly on my 2011 Sonata.

Is that a Buick?

That power steering pump is fried!

your video is not playing right.

why was it so noisy after replacement? Air?? What is the proper bleeding procedure for this truck. I like to have whisper quiet steering if possible.

Hey thanks a lot! That was a quick and easy fix, thanks for sharing

This was a great video. However, I am having a problem reconnecting the steering shaft coupler to the gear box. Do you have any tips?

thank you for solving a problem I've had for many months D:!

I recently replaced my clock spring and didn't notice these slots needed aligned. I had the extract same symptoms and this fixed my issue. Thank you!

Love that shifter, very cool idea.. K.I.S.S. 🙂

Do this work on 2017 Hyundai