- 18
- 10 311
Nathan Schiermeyer
Приєднався 7 тра 2012
Відео
Maintainer Body display Text "aux" rename
Переглядів 13Рік тому
This shows the process of how to upload the renamed aux1 aux2 aux3 switches. The software and usb drive must be obtained from Maintainer
Battery holder Dewalt 20v & Milwaulkee M18
Переглядів 15Рік тому
Battery holder Dewalt 20v & Milwaulkee M18
TD1140 & TD2100 change backlight brightness
Переглядів 153 роки тому
TD1140 & TD2100 change backlight brightness
Programming mins & maxes on TD1140
Переглядів 1174 роки тому
If you want to do it "live", when in programming mode, push both aux1 and aux2 (or air compressor & flood lights), and hydr" will say "enable" instead of "disable". it will function the crane while programming then. For questions call 712-324-5001 & ask for Nathan. J:\Engineering\Project Management\CAN\Eaton-Power Systems\Procedures\TD1140 Min Max Instructions.docx
Maintainer - Pushbutton TD1140 sensor zeroing
Переглядів 254 роки тому
How to Zero the boom angle, Extension length, and weight from the remote screen.
I see the wrinkles in the top seat right above where the listing wire goes across. Factory cars have no wrinkles there. Mine look the same. Poor fit on TMI account. The 65-68 fit perfect
I would have to agree. it has settled out some, but wasn't quite stitched right at the top, right under the red stripe.
It didn't even show him covering the back of the seat. The part I needed to make sure I done mine right. The video picked up after he had done that part
@kimwright6908 sorry. The back portion was pretty straight forward compared to the seat bottom. Pull it over. listing wire hog rings like bottom. I'll see if I have a video of that portion and just missed uploading it
How much do you charge. Great idea on the zip ties.
The two flaps on the underside of the seat back get ringed before the full under section with the wire gets ringed. Just a helpful reminder if you do this again.
Thank you!