- 7
- 57 659
Fix it Ramon
Приєднався 22 гру 2012
Chevy Heater hose connector Removal 2000-2007 Silverado
how to remove heater hose connector from heater core on 2000-2007 chevy silverado
Переглядів: 1 224
Відео
2006 Ford F150 5.4L Code P2006
Переглядів 49 тис.4 роки тому
Code P2006 Intake runner control stuck closed faulty control solenoid
ECX Ruckus Jumps Over Car
Переглядів 665 років тому
Stock ECX Ruckus 1/10 Rc Truck jumps over a car with only a flat cardboard box placed on the trunk of the car no damage was done to either vehicles 🤣😂 the Ruckus still lives and hasn't had any parts replaced other than the brush motor being replaced for a brushless system
Separating hub from brake rotor
Переглядів 4,3 тис.6 років тому
Separating hub from front brake rotors
Great video
I took all mine out
You’re Awesome Ramon, when I overhauled my 08 back in 18’ I couldn’t find diddly squat about this IMRC so thank you for the info!
Is that a 06 intake or 09 intake. It looks like a 09. Because 04 thru 08 do not look like that.
It's the same. It's just upside down and backwards
Dope. Love the soundtrack
Hello Do you know where a roush f150 supercharged truck might have this part? I have the same code and could see the back but can’t seem to locate this IMRC
Upon placement of the new runner valve.... are the flaps supposed to b closed or open... when i installed it the flaps are closed is this correct??
Ryan did you get an answer, I’m doing one today and don’t know if the flap suppose to be open or closed when installing
@@ginopr200112 shit bro we did it and i forgot.. the actuator can go on both ways so be careful.. it should come with instructions on which way the actuator will sit which is the way the flaps need to be
@@NORCALPYRO_how did it turn out I'm currently doing one now
@hollywoodjohnson5443 fine just when u take the old intake off take a pick because like i said the rods can go on both ways
@hollywoodjohnson5443 they should also give you a info sheet with the new part on how its installed
THANK YOU
Running into a similar issue currently. What did you figure out, did your repair solve the issue?
I apologize for the late response, I ended up replacing the intake manifold runner control valve (black box in the video) as well as replacing the connector. Terminals on the connector were out of round causing a faulty connection
Wow Ramon still no intro to video bro it sucks 😂😂😂
Football players are lucky....if a cop did that people would be in the streets crying
Let's punch a helment and break your hand.
wow Cleveland look at your record.
And they were winning the game. 8 seconds left, emotions run high, shake hands, apologize and go get a beer. Geez all these videos of how bad this was. For a couple minutes. Geez just let it go. Shit happens. That's nothing. Nhl has true tough guys and once the game is over that's it. No harm done.
So probably dumb question, does this apply to all rotor-hub assemblies? 86 Bronco/F150 setup here. Wanna change the rotors to some high performance rotors but none include the hub as one piece