Відео

I just started my training for line boring, I need a lot of practice with my measurements. Do you recommend anything? I’m totally fresh

Did you touch off a tool of known length on the calibration ring prior to calibrating

No good video, dont see anything

Screw fraction I sick at them.

32÷64÷0.5 64÷32=2 Wtf?!

Thanks for your videos.. very good 👋

why no sound?

no sounds sir .

Great intro music quiet audio though

thank for the video sir. im a begginer at cnc .. im here japan

Axis noise 😂

Didn't explain well enough realy..

chúc mừng năm mới ạ

Hanzhen harmonic drive gear , robot joint , strain wave reducer, over 30 years experience ,

That is similar to a steel rule my father had. Most have the common 1/2 1/4 1/8 1/16 fractions but his was for the printing industry that had "points" and other scales as well. It was related to font sizes but amazingly the size of fonts that we understand from our modern computer programs do not actually correspond.

thank You , just started using steel rules in the 10/1000 and 1/100 range

If one of my operators took the battery out of the probe, I would shit. Our probe just lives in the tool carousel with all the other tools. They go to sleep after a few min. The batteries last for months or years. I trust the machine more than I trust a human to be taking out the batteries and handling the probe multiple times a day. One drop on the floor and it’s toast.

twabt vun.fyi

So, basically, you give the largest numbered reading possible. You'd say 1/2 an inch rather than 500th of an inch though both are correct and accurate, right? This subject really interests me as I've never understood the decimal form of a fraction. Thanks for adding clarity.

So what's the point of pulling out the batteries again??? We use our probes on an hourly basis, and the batteries last for months. Plus, technically, you're supposed to recalibrate the probing system with each battery change, so this seems highly counter productive.....

Special guest appearance by J Caylor II @ 1:18:48 lol

Quality video ending

"Or I'll break your neck." forgot your farewell moniker.

Since the stylus can bend, is it theoretically possible that when you jog the dial test indicator on it to check runout, the indicator can push the stylus out of center from spindle? You could then be adjusting the runout of the tip to 0 but not actually be aligned with the spindle.