Відео

Those 1980 to 1986 trucks are getting hard to find. Especially one that is not beat up or rusted out. I remember these trucks being brand new.

So you’re just screwing right into the pipe?

How much do you want for it?

Actuator 14-tooth spline socket was $11.99 on Amazon.

You should have rotated it forward aswell as reverse.

Thanks. Will try all you did tomorrow. Wish me me luck

Did your kit come with new bolts? Where did you get this kit from? I need to replace mine. 78'cj5. Thank you

How tf do you remove the blue connector lol

I just replaced that light with the original part, it was broken, I removed the old one, cleaned everything the gasket should touch, I tightened a little bit, it rained 3 days later and saw wet only the left corner of the ceiling, so more likely is the rear door weather strip, but also I discovered the main leak, which are both vents between the bed and the cab

Do you have to take the strut out or was it needing a replacement too?

Thanks for this video, I'm down in S Florida so I dont care about the heat. one question, I'm trying to figure out if its my Climate or AC control Module "as in the one you showed at the end of this video" OR if its my Blower fan Module or resistor as some call it under my glove box. The issue is my fan will only blow on the highest speed #5, not on 1-4. On top of this the air is uneven distribution, blows out the passenger sides but not the drivers side. This is for the AC. I actually haven't checked the heat, I never use it.. Do you know how I can narrow that down? Thanks in advance.

I used tape to hold up the window

I just cut a hole in the floorboard to change my pump…

youneed to slow down where us old folks can see what your doing.

Love you Thank you for the video

Where is the TCM located on 03 Yukon

Who did you order your Tcm from ?

How much would it cost to do this job

This is a dumb video he never showed what the title said you was supposed to be showing the tank replacement not talk about it 🤷🏼‍♂️

I picked up a 86 F-150 4 x 4 extended cab paid 450 for the truck and another $50 to get home it has only 55,000 miles on it. A old lady used it for her farm truck only it's never seen Highway very little these little bullnose are getting hard to find 175,000 that's not bad on a little truck there's a lot of parts out there available for it they quite have not hit the market yet like the dent side 70s trucks and you definitely scored that for $200 can't wait to see what you going to do with it in the future and that is a smog pump delete it don't need it

Merci beaucoup ❤❤❤❤❤❤

there’s a grommet under the passenger floor board you could drill straight through it that’s what i did i’m having an issue though my subs are only putting out mid to high end bass. my lows are only coming from my factory sub. i been scratching my head for days

POS. Don't buy it.

Great vid!! You have the same engine as my 97 bayliner

Then it’s probably your neutral safety switch

The replacement part is currently $54. You sir saved me over $300. Thank you!!!

Dealership quotes $1k for this job wtfffff lol

What did you really change to have power to fuel pump did you change oil pressure switch too? Please I have the same problem!

What is the fan shroud model or where did you get it from cus i can't find one for my 5.2 V8

Sponsored by dui Miller lite😂

Thanks for doing everything out of frame

Sad times. She'll be back up and going soon.

I'm chasing a problem with my shift indication on my dash as well. The little line that shoes under each gear position drops in and out. The truck is driving fine (no limp mode), but when the line goes out under the R indicator, my aftermarket backup camera doesn't work and cruise control drops out when the line drops out under D during Drive. It comes and goes and sometimes stays solid like there is nothing wrong at all. I have inspected as much of the associated wiring, but can't find any issues. I don't get any codes when I check with a standard engine scan tool. I am thinking it is the gear position switch inside the transmission or the TCM. The TCM is easier to access and it's about the same place. Any thoughts?

Look pretty simple can you do a video on the front struts?

Perfect,..just what I needed. Thanks for posting!

Very helpful. Thank you thank you.

looks fun but damn the camera exposure makes it look like you need brighter headlights haha it looks scary af from our perspective!

Put 4x4 under it

I was told to loosen the hub before the tire is off.. is that possible?

I would allow the wet fuel to evaporate before I started making sparks and I always have a fire extinguisher close by.

Thank you!!

I just found one of these hooked up very messily to the ecu of a car i bought. Along with an apexi rev/speed meter

'07 Silverado 2500 6.0L (NewBody)... What if there's no harness and TCM behind the BCM; where else would I find it on this truck? Great video, by the way.

Dang mountain stole my hat

Wish it had a rotating end...hmmm I not sure what this is......Thats a quick-connect and yes it rotates

Good times

Nice!

Tks for The tutorial

Hey man , I just found your channel. We have to same boat, down to the year lol

So glad i found your video I installed a newer 6L80e in my 2009 Avy. Took it to the dealer to flash and they some how bricked the TCM. No gear selection light, whining and grinding from the pump (transmission), and other mess. They will not take ownership they messed up. Im so mad!! Any suggestions?? They say transmission is bad. Lies